Aeotec ZWA019 Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Аксессуары Aeotec ZWA019. Aeotec ZWA019 13 страниц. Water sensor
Также для Aeotec ZWA019: Руководство (3 страниц), Руководство пользователя (9 страниц), Руководство пользователя (9 страниц)

3.7

How to factory reset

This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used

when the primary controller is inoperable.

Once Cover is removed and the tamper switch is tripped, push the tamper for 5 seconds until the RED LED blinks once.

Then release tamper and push it again for 5 seconds while the RED LED is blinking until the GREEN LED blinks once.

3.8

The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries of

different charging level or different brands.

3.9

Once installed the sensor will report sensor status changes to a central Z-Wave controller using notification commands.

Additionally, the sensor can directly control other devices using association group 2.The device is protected by a tamper

switch.

Link testing

When activated by configuration parameter #5 the device can perform a link test with device No.1. Double-clicking the

tamper will start the process. As a result, the GREEN LED will blink two times in case of success and the RED LED will

blink two times in case of failure.

AEOTEC User Manual

Page 5