Aeotec Nano Shutter Руководство - Страница 4

Просмотреть онлайн или скачать pdf Руководство для Контроллер Aeotec Nano Shutter. Aeotec Nano Shutter 7 страниц. Z-wave motor controller

With your Nano Shutter now working as a part of your smart home, you'll be able to

configure it from your home control software. Please refer to your software's user guide

for precise instructions on configuring Nano Shutter to your needs.

Removing your Nano Shutter from a Z-Wave network.

Your Nano Dimmer can be removed from your Z-Wave network at any time. You'll need to use

your Z-Wave network's main controller. To set your Z-Wave controller/gateway into removal

mode, please refer to the respective section within your controller instruction manual.

1. Set your Z-Wave controller into removal mode.

2. Press the Action Button 6 times on the Nano Dimmer or toggle the external manual switch 2

times in fast succession.

3. If the Nano Dimmer has been successfully removed from your Z-Wave network, its RGB LED

will remain colourful gradient. If the removal was unsuccessful, the RGB LED will still be solid

(following the state of the output load), repeat the instructions above from step 1.

Controlling the Nano Shutter.

Use any of the below methods to control the Nano Shutter.

Pressing the button on the external (Wall) switch will be able to spin the motor up/down/stop.

Through the usage of Z-Wave commands built into Z-Wave certified controllers and gateways.

(The specific Z-Wave commands supporting this function are the Basic Command Class and

Multilevel Switch Command Class.) Please consult the operation manual for these controllers

for specific instructions on controlling the Motor Controller.

A short press on the button on the Motor Controller will spin the motor up/down/stop.

Change Mode on the External Switch/Button Control.

Nano Shutter by default is set to be controlled via 2-state (flip/flop) external wall switch.

Pushing the button 6 times in quick succession on the Nano Shutter will swap between this

default mode and the momentary push button external wall switch mode

Reset your Nano Shutter

If at some stage, your primary controller is missing or inoperable, you may wish to reset all of

your Nano Shutter's settings to their factory defaults. To do this, press and hold the Action Button

for 20 seconds and then release it. Your Nano Shutter will now be reset to its original settings,

and the green LED will be solid for 2 seconds and then remain the colourful gradient status as a

confirmation.

Technical Specifications

Module Number: ZW141.

Operating Temperature: 0

Operating Distance: Up to 100feet/30 metres indoors and 427feet/130 metres outdoors.

AC input:

Version Input

℃

to 40

℃

Working band

Page 4