Aeotec WallMote Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Контроллер Aeotec WallMote. Aeotec WallMote 8 страниц.
Также для Aeotec WallMote: Быстрый старт (3 страниц), Руководство пользователя (9 страниц)
Печатать страницу
4.10.2017
Your WallMote Quad has a internal rechargeable lithium battery that will allow you to charge it when it is in low battery.
The charger's output should be a micro USB terminal with the specification of output DC 5V/1A. When the WallMote
Quad is in charge state, the orange LED will be on. If the orange LED is off and the green LED remains on, then it
indicates that the battery charge is complete.
Note: When the WallMote is in low battery, you will see the orange LED will blink when you touch the control buttons.
Otherwise, if the blue LED blinks when touching the buttons, which means the battery is in normal level.
Waking up WallMote.
In order to configure WallMote, you must either (1) wake up WallMote using the below button press function.
1. Press and hold WallMote Action button
2. Wait until the RGB LED turns into a Yellow/Orange Color and beeps.
3. Release WallMote Action Button
The LED on WallMote will now rapidly blink its Yellow/Orange LED while it is in its awake state. You may send in
any configurations or commands from your current gateway to configure your WallMote.
4. Tap the Action Button on WallMote to put WallMote back to sleep, or wait 10 minutes. (recommended to manually
put it back to sleep to conserve battery life).
Testing Health Connectivity.
You can determine the health of your WallMotes connectivity to your gateway using a manual button press, hold, and
release function which is indicated by the LED color. This will help you maximize the battery life based on the health of
your WallMotes communication to your gateway. You'll be able to see a maximum battery use of 3 months of use over
green LED indication listed below.
1. Press and hold WallMote Action button
2. Wait until the RGB LED turns into a Purple Color
3. Release WallMote Action Button
The RGB LED will blink its Purple color while sending ping messages to your gateway, when it has finished, it will blink
1 of 3 colors:
Red = Bad Health
Yellow = Moderate Health
Green = Great Health
Be sure to watch for the blink, as it will only blink once very quickly.
Resetting your WallMote Quad.
If at some stage, your primary controller is missing or inoperable, you may wish to factory reset your WallMote Quad's
which will remove it from its network that it is paired to, and reset all configured settings back to default. To do this,
follow the steps below:
1. Press and hold the Action button (20 seconds).
https://aeotec.freshdesk.com/support/solutions/articles/6000162392-wallmote-quad-user-guide-
WallMote Quad user guide. : Aeotec by Aeon Labs
7/8