Aeotec MultiSensor 7 Руководство пользователя - Страница 3
Просмотреть онлайн или скачать pdf Руководство пользователя для Датчики безопасности Aeotec MultiSensor 7. Aeotec MultiSensor 7 8 страниц.
Также для Aeotec MultiSensor 7: Руководство пользователя (5 страниц)
Печатать страницу
22/07/2021
1x Tap (when already paired)
Press and hold [1, 2 seconds) No LED
Press and hold [2, 5 seconds) Solid
Press and hold [5, 9 seconds) Solid
Press and hold [9, 15 seconds) Solid
Press and hold [15, 20
seconds)
Press and hold [20+ seconds)
Important safety information.
Please read this and other device guides carefully. Failure to follow the recommendations set forth by Aeotec Limited
may be dangerous or cause a violation of the law. The manufacturer, importer, distributor, and/or reseller will not be
held responsible for any loss or damage resulting from not following any instructions in this guide or in other
materials.
MultiSensor 7 is intended for use in dry locations only. Do not use in damp, moist, and/or wet locations.
Do not use rechargeable CR123A batteries.
Keep product and batteries away from open flames and extreme heat. Avoid direct sun light or heat exposure. Always
remove all batteries from products that are being stored and not used. Batteries may damage the appliance if they
leak. Do not use rechargeable batteries. Ensure correct polarity when inserting the batteries. Improper battery use
https://aeotec.freshdesk.com/support/solutions/articles/6000232605-multisensor-7-user-guide
MultiSensor 7 user guide : Aeotec Help Desk
Sends NIF / Excludes device
Solid
Purple
if Z-Wave controller is in unpair mode, starts blue LED
fade in/out if unpaired and factory reset successfully.
N/A
Quick Wakeup
LED will disappear as soon as you release its button.
Red
The MultiSensor 7 will send a wakeup report to your Z-
Wave Controller to take in any queued z-wave
commands waiting in your controller.
Long Wakeup Mode
LED will remain solid Orange upon release of its button
for 5 minutes maximum (or until told to sleep by user or
Orange
z-wave controller). This will allow you to easily
configure this device while the sensor is used with
battery power assuming your Z-Wave controller does
not queue the command.
Communication Health Test (Direct gateway
communication - does not test through repeaters).
This will test your MultiSensor 7 direct communication
to your Z-Wave Controller. It will remain Cyan while it is
testing.
Cyan
Once finished it will become a solid color for 2 seconds
as red, yellow, or green to indicate health:
Red = Bad health, can't communicate at all.
Yellow
some communcation missed.
Green = Great health
Blinking
Red
Release here to cancel Factory Reset.
Blue fade in/out
Factory Reset.
for 2 seconds.
= Moderate health, could use improvement,
3/8