3Com 10G Руководство по установке

Просмотреть онлайн или скачать pdf Руководство по установке для Сетевое оборудование 3Com 10G. 3Com 10G 4 страницы. Switch 4200g 10g interface module

1.1 Appearance and front panel

Figure 1 Appearance of an XFP interface module

Figure 2 Front panel an XFP interface module

1.2 Installation

Step 1: Put on an ESD-preventive wrist strap and verify it is properly

grounded. Then remove the XFP interface module from the package.

Step 2: Loosen the filler panel mounting screws on the rear panel of the

switch with a screwdriver and remove the filler panel.

Step 3: Hold the fastening screws on the front panel of the XFP interface

module, and gently push the module in along the slot guide rail until the

module is in close contact with the switch.

Step 4: Tighten the fastening screws with a screwdriver to secure the XFP

interface module.

3Com Switch 4200G

10G Interface Module

Installation Guide