Acom 1010 Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Усилитель Acom 1010. Acom 1010 20 страниц. External radio frequency power amplifier
Также для Acom 1010: Документ со схемами (14 страниц), Схематические диаграммы (15 страниц)

Печатать страницу

a) Connect the station's grounding system to the wing-nut ground stud of the amplifier (on the rear

panel, marked GND in Fig. 2-1).

b) Connect a suitable coaxial cable between the transceiver output to the amplifier (rear panel) RF

INPUT SO-239 connector, using PL-259 connector.

The coaxial cable from the amplifier's output must be capable of handling the

amplifier's output power safely, particularly on the 10-meter band. It is suggested

that, at a minimum, RG8X (including RG8MINI, RK50-4-11, RK50-4-13) or, even

better, RG213 (including RK50-7-11) coaxial cable be used.

c) Connect a suitable coaxial cable from the antenna to the appropriate amplifier output (on the rear

panel, marked ANT1 or ANT2), using a PL-259 plug.

Run a shielded cable from the "ground on transmit" socket or terminal on your transceiver

to the amplifier rear panel KEY-IN socket. The KEY-IN socket uses a standard RCA phono plug

Your amplifier will not work if KEY-IN is not connected properly.

Transceiver producers assign different names to their "ground on transmit" output terminals, e.g., TX-

GND, SEND, T/R-LINE, etc. Some transceivers may require that "ground on transmit" be implemented

by a software command, or by changing the setting of a switch on the rear panel or inside the transceiver.

Check your transceiver's manual for more information on keying amplifiers.

Fig. 2-1 Connections

CAUTION

NOTES