Whirlpool 3360620 Руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке для Стиральная машина Whirlpool 3360620. Whirlpool 3360620 8 страниц.
Печатать страницуBefore you start...
Your safety and the safety of
others is very important.
We have provided many important
safety messages in this manual and on
your appliance. Always read and obey all
safety messages.
This is the safety alert
symbol. This symbol alerts
you to hazards that can kill or
hurt you and others. All safety
messages will be preceded by the safety
alert symbol and the word "DANGER" or
"WARNING". These words mean:
Check location where washer will be
installed. Proper installation is your
responsibility. Make sure you have
everything necessary for correct
installation.
Do Not store or operate washer below
32°F some water may remain in
washer).
See Use & Care Guide for
"Winterizing" information.
Untape and
open washer
lid. Remove
packages and
hoses from
washer.
No. T20 Torx
screws
On coin-operated washers, front
access to the pump area is available
by removing the two, No. 10 Torx
screws and then removing the front
panel. Non-coin-operated washers
do not have a removable front panel.
The cabinet and top assembly must
be removed by removing clips under
console on the non-coin-operated
washer.
PAGE 2
DANGER
You will be killed or seriously injured if
you don't follow instructions.
WARNING
You can be killed or seriously injured if
you don't follow instructions.
All safety messages will identify the hazard,
tell you how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
Single washer
Grounded
installations require
electrical outlet
12" minimum risers
is required. See
to provide an air
Electrical
cushion and
requirements.
prevent noise and
damage to valves.
Level floor: Maximum slope
under washer — 1 inch
A floor drain should be provided
under the bulkhead. Prefabricated
bulkheads with electrical outlets,
water supply lines and drain facilities
should be used only where local
codes permit.
Non-coin-operated washers are
equipped with a console, push to
start timer, selector switches and
indicator lights (not pictured).
Coin-operated washers are equipped
with a meter case, console, timer,
selector switches and indicator lights.
The coin slide mechanism, slide
mounting bolt, slide extension, service
door panel lock and key, top lock
and key, coin vault, and coin vault
lock and key are not included with
this washer and are needed to
complete installation. These items are
available from usual industry sources.
Hot and cold water faucets must be
within 4 feet of the back of the
washer and provide water pressure
10-100 PSI. A pressure reduction valve
should be used in the supply line
where inlet pressure entering the
building exceeds 100 PSI to prevent
damage to the washer mixing valve.
Water heater: Set
to deliver 140°F to
160°F water to the
washer.
Standpipe drain system: Needs a two-
inch minimum carry-away capacity
of 17 gallons per minute. Top of
standpipe must be at least 34 inches
high and no higher than 72 inches
from bottom of washer.
Support: Floor must be sturdy enough
to support loaded washer weight of
315 pounds.
Important: Observe all governing
codes and ordinances.