Whirlpool 49 Руководство по эксплуатации - Страница 12
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Стиральная машина Whirlpool 49. Whirlpool 49 14 страниц. 5kg, 1000rpm fully integrated washing machine awo/d 049
Печатать страницу
30110447GB.fm Page 12 Thursday, May 10, 2007 12:35 PM
Red indication lights up
"Service"
Check which of the previously described situations could be the origin of the fault and
follow the corresponding instructions.
Black process 45.0° 100.0 LPI
Description
Possible causes
"Electrical module fault"
Select and start the "Drain" programme or push the "Reset" button for at
least 3 seconds.
"Water level too high" (after programme cancellation or false operating).
Switch off the appliance (by pressing the "On/Off" button or by turning
the programme selector to the "Off/O" position - depending on the
model) and then switch it on again, select the programme "Drain" and
start within 15 sec.
"Waterstop fault"
Switch off the appliance (by pressing the "On/Off" button or by turning
the programme selector to the "Off/O" position - depending on the
model), pull out mains plug and turn the water tap off. Tilt the appliance
forward carefully to allow collected water to flow out from the bottom.
Then:
• Plug in the appliance again.
• Turn the water tap on (if water immediately flows into the appliance
without the appliance being started, there is a failure; turn off the tap and
notify the After-Sales Service).
• Select and start the desired programme again.
"Overfoaming"
Too much foam interrupted the wash programme.
• Select and start the "Rinse & Spin" programme.
• Afterwards select and start the desired programme again, using less
detergent.
If any of the faults described above persist, unplug the appliance, turn off
the water tap and contact our After-Sales Service (see next chapter).
GB 12
Solutions