Whirlpool 6AWTW5700X Руководство по установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке для Стиральная машина Whirlpool 6AWTW5700X. Whirlpool 6AWTW5700X 12 страниц. 220–240v 50 hz washer
Печатать страницу
ELECTRICAL REQUIREMENTS
A 230 volt, 50 Hz., AC only, 10-amp, fused electrical supply is
n
required. A time-delay fuse or circuit breaker is recommended.
It is recommended that a separate circuit breaker serving only
this appliance be provided.
This washer is equipped with a power supply cord having
n
an earthing plug. The plug should be accessible for
disconnection from the supply.
To minimize possible shock hazard, the cord must be plugged
n
into a mating, earthing-type outlet, earthed in accordance with
local codes and ordinances. If a mating outlet is not available,
it is the personal responsibility and obligation of the customer
to have the properly earthed outlet installed by a qualified
electrician.
If codes permit and a separate earth wire is used, it is
n
recommended that a qualified electrician determine that the
earth path is adequate.
Do not earth to a gas pipe.
n
Check with a qualified electrician if you are not sure the washer
n
is properly earthed.
Do not have a fuse in the neutral or earth circuit.
n
When in the installed position the mains plug must be
n
accessible for disconnection.
NOTE: In accordance with the European EMC Directive
(2004/108/EC), the maximum electricity supply system
impedance to which the electric washer should be connected
is declared to be 0.231 + j0.144 ohms.
EARTHING INSTRUCTIONS
This washer must be earthed. In the event of a malfunction
or breakdown, earthing will reduce the risk of electric
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-earthing conductor and an earthing plug. The
plug must be plugged into an appropriate outlet that is
properly installed and earthed in accordance with all local
codes and ordinances.
WARNING:
Improper connection of the equipment-
earthing conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly earthed.
Do not modify the plug provided with the appliance – if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
INSTALLATION INSTRUCTIONS
Before you start: remove shipping materials
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
1.
Move washer
1.2 m
(48")
Move washer to within 1.2 m (4 ft) of its final location; it must
be in a fully upright position.
NOTE: To avoid floor damage, set washer onto cardboard
before moving it and make sure lid is taped shut.
2.
Remove shipping base
To avoid damaging floor, place cardboard supports from
shipping carton on floor behind washer. Tip washer back
and place on cardboard supports. Remove shipping base.
Set washer upright.
IMPORTANT: Removing shipping base is necessary for proper
operation. If your washer includes a sound shield, please refer
to the instructions included with the sound shield to install it at
this time.
5