Whirlpool 8316243 Руководство по установке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке для Стиральная машина Whirlpool 8316243. Whirlpool 8316243 17 страниц. Commercial washer 120-volt, 60-hz models

Печатать страницу
Now start...
WARNING
Excessive Weight Hazard
Use two or more people to move
and install washer.
Failure to do so can result in back
or other injury.
Pull the strap completely
out of the washer.
1.
Remove tape that covers
shipping strap. Pull to completely
remove the shipping strap with 2
cotterpins from the inside of the washer.
Pull firmly to remove the end of
shipping strap from the back of the
washer. The shipping strap plug must
be completely removed from the
washer for the self-leveling legs to
be released.
Save the shipping strap for use in
Step 6.
PAGE 4
Use new hoses and washers that
came with your Whirlpool washer.
Replace inlet hoses after 5 years of
use to reduce the risk of hose failure.
Inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are
found. When replacing your inlet
hoses, mark the date of replacement
on the label with a permanent
marker.
2.
Insert a flat washer into each
end of the inlet hoses. Check that
washers are firmly seated in
couplings.
shipping
tape
cold
water
inlet
valve
hot water
inlet valve
3.
Attach hose to bottom inlet
valve opening first. Then second hose
to top inlet. Tighten couplings by
hand; then use pliers to make an
additional two-thirds turn.
Slide washer onto cardboard or
hardboard before moving across
floor.
4.
position. Put "hook" end of drain hose
into standpipe. Estimate length of
drain hose needed when washer is in
final position. Hose must be cut
exactly to length so "hook" end is
held tightly over edge of standpipe. If
washer
coupling
drain hose is too long, cut straight end
of hose. (Do Not cut "hook" shaped
end of drain hose.)
DO NOT FORCE EXCESS LENGTH OF
DRAIN HOSE DOWN THE STANDPIPE.
THIS COULD CAUSE SIPHONING. See
Step 6.
Inlets are plastic.
Do Not strip or
crossthread.
5.
drain connector. Push drain hose onto
washer connector. Use pliers to open
clamp and slide clamp over drain
hose. Check for good fit.
6.
approximately 16 inches (40.6 cm)
from the plug end of the shipping
strap. Cut this shipping strap at this
point.
Check that hose is not
twisted or kinked and is
securely in place.
Put "hook" end of drain
hose into standpipe.
Tightly wrap the shipping
strap around the
standpipe. Push plug into
the nearest hole in the shipping strap.
Move washer close to final
Place hose clamp over washer
16" (40.6 cm)
Measure and mark a point