Whirlpool AWE 7515 Руководство пользователя - Страница 10

Просмотреть онлайн или скачать pdf Руководство пользователя для Стиральная машина Whirlpool AWE 7515. Whirlpool AWE 7515 19 страниц.

Печатать страницу

IFU-TL HR GB.fm Page 10 Friday, November 7, 2008 2:30 PM

CARE AND MAINTENANCE

Detergent dispenser

Clean the detergent dispenser regularly, at least three or

four times a year, to prevent detergent build-up:

1. Push in the buttons on each side of the dispenser.

2. Pull the dispenser towards you and remove it.

3. Wash the dispenser using running water.

4. Replace the siphon caps in the dispenser (if removed).

5. Replace the dispenser by locating the bottom tabs in the lid

Water inlet hose filter

Check and clean regularly (at least two or three times a year).

1. Unplug the washing machine.

2. Turn off the tap.

3. Unscrew the hose from the tap.

4. Carefully clean the filter located at the end of hose, without

5. Screw the flexible hose back onto the tap by hand. Do not use

6. Turn on the tap and check that the connections are

7. Plug the washing machine back in.

Water inlet hose

Check the inlet hose regularly for brittleness and cracks and

replace it if necessary using a new hose of the same type.

The inlet hose as shown on picture "A" has a safety valve to

prevent the appliance against uncontrolled water inlet; if the

safety valve inspection window is red, the safety valve has been

activated and the hose must be exchanged. Contact out After-

Sales Service or your specialist dealer to obtain a new inlet hose.

If your inlet hose has a transparent hose coating (fig. "B"),

periodically check the colour of the transparent coating. If the

transparent hose coating turns into an intense red, this is an

indication that the hose may have a leak and should be replaced.

Contact our After-Sales Service team or specialist dealer to

obtain a replacement hose.

Black process 45.0° 100.0 LPI

Downloaded From WashingMachine-Manual.com Manuals

A small quantity of water can remain in the dispenser. It is

advisable to carry the dispenser in an upright position.

You can also remove the siphon caps in the dispenser for cleaning.

Make sure that they lock in place.

holes and pivot until both of the upper buttons lock.

Note: ensure that the detergent dispenser is correctly

reinstalled.

disassembling it, for example with a tooth-brush.

Note: Do not submerge the hose in water.

pliers (risk of squashing the joint).

water-tight.

Safety valve

inspection

window

GB 10