Whirlpool AWO/C 7420 S Руководство - Страница 8

Просмотреть онлайн или скачать pdf Руководство для Стиральная машина Whirlpool AWO/C 7420 S. Whirlpool AWO/C 7420 S 16 страниц.

Печатать страницу

CARE AND MAINTENANCE

Appliance exterior and control panel

• Wash down with a soft damp cloth. Dry with

a soft cloth.

Appliance interior

• After each washing, leave the door open for some

time to allow the inside of the appliance to dry.

• If you never or seldom wash your laundry at 95°C,

we recommend to occasionally run a 95°C programme

without laundry, adding a small amount of detergent,

to keep the interior of the appliance clean.

Do not use detergents containing solvents, scouring powder, glass or general purpose cleaners, and

flammable fluids. They may harm the plastic surfaces or other parts.

Cleaning the detergent dispenser

1. Pull out the dispenser drawer until it stops.

Press with your finger on the small depression over the "PUSH"

marking (picture "A") to release the drawer and pull it out

completely.

2. Remove the siphon from the softener chamber by pulling it

upwards (picture "B").

3. Wash all the parts under running water.

4. Clean the dispenser compartment with a damp cloth.

5. Refit the siphon in the softener chamber by pushing it down until

it stops; then push the dispenser drawer back into the dispenser

compartment.

Water inlet hose(s) (picture C, D or E - depending on

model)

Check regularly for brittleness and cracks. In case of a damage, replace

it by a new hose of the same type, available through our After-Sales

Service or your specialist dealer.

If the inlet hose of your washing machine corresponds with the model

on picture "D", periodically check the safety valve inspection window:

if it is red, the hose's waterstop function was triggered, and the hose

must be exchanged by a new one from our After-Sales Service or your

specialist dealer. This model may have a release lever which must be

pressed down while unscrewing the hose.

If your supply hose has a transparent hose coating (picture "E"),

periodically check the colour; if it intensifies locally, the hose may have

a leak and should be replaced. Contact our After-Sales Service team or

specialist dealer to obtain a replacement hose.

Cleaning the mesh filter in the water inlet hose(s)

1. Close the tap and loosen the inlet hose on the tap.

2. Clean the internal mesh filter and screw the water inlet hose

back onto the tap.

3. Now unscrew the inlet hose on the rear of the washing machine.

4. Pull off the mesh filter from the washing machine connection

with universal pliers and clean it.

5. Refit the mesh filter and screw the inlet hose on again.

6. Turn on the tap and ensure that the connections are completely

water-tight.

Door seal

• Dry the door seal after each washing with an

absorbent cotton cloth; make sure that the door

seal is completely dry before closing the door of

the empty washing machine.

• Check the condition of the door seal periodically.

Filter

• Check and clean the filter regularly, at least two

or three times a year (see "Draining Residual

Water/Cleaning The Filter").

GB 8

Release lever

Safety valve

inspection window