Ariston ASL 65 VXS NA Руководство по эксплуатации и установке - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и установке для Сушилка Ariston ASL 65 VXS NA. Ariston ASL 65 VXS NA 40 страниц. Tumble dryer
Также для Ariston ASL 65 VXS NA: Буклет по уходу, использованию и установке (16 страниц), Брошюра и технические характеристики (8 страниц), Буклет по уходу, использованию и установке (40 страниц), Руководство по ремонту (20 страниц)

Troubleshooting

Before you call our Customer Care Department, go through the following troubleshooting suggestions:

Problem:

The dryer won't start.

Drying cycle will not begin.

Its taking a long time to dry.

Program finishes and clothes

are damper than expected.

The display shows a fault

code F followed by one or two

numbers.

If you still have a problem call our Customer Care Department on: 1 877 356 0766

This dryer is a complex machine. Repairing it yourself or having a non-authorized person try to repair it could

cause harm to one or more persons and to the machine, and could invalidate the spare parts warranty.

Call an authorized service center if you experience problems while using the machine.

Contact number: 1 877 356 3766

Possible causes / Solution:

The plug is not plugged into the socket, or not making contact.

There has been a power outage.

The fuse has blown. Try to plug another appliance into the socket.

You are using an extension cord? Try to plug the dryer's power cord

directly into the socket.

The door is not closed securely?

The PROGRAMS knob has not been set properly (see Start and Programs).

The START button has not been pressed (see Start and Programs).

You have set a delay time (see Start and Programs).

The filter has not been cleaned (see Maintenance).

The correct program has not been selected for the type of fabric you are

drying (see Start and Programs).

The exhaust duct is obstructed (see Installation).

The air intake vent is obstructed (see Installation).

The permanent ventilation flap on the storm cover is obstructed (see

The items were too wet (see Laundry).

The dryer was overloaded (see Laundry).

! For safety the dryer has a maximum program time of 3 hours. If an

automatic program has not sensed the required final moisture in this time

the dryer will complete the program and stop. Check the above points and

run the program again, if the results are still damp, contact our Customer

Care Department.

Note down the code and contact the our Customer Care Department.