Whirlpool 4322658A Руководство - Страница 26
Просмотреть онлайн или скачать pdf Руководство для Холодильник Whirlpool 4322658A. Whirlpool 4322658A 48 страниц. In-door ice system
Печатать страницуOPTICS DIAGNOSTICS FOR
ORIGINAL DESIGN BOARDS
KIT #4388635 SUBS TO #4389102
EMITTER—PART #2198585
RECEIVER—PART #2198586
To initiate an optics check, perform the follow-
ing steps:
1.
Open the freezer door.
2.
Remove enough ice from the ice bin so
that the ice level is at least one inch below
the U-shaped cutouts in the bin.
Infrared Emitter Beam
U-Shaped
Cutout
Ice
Level
3.
Make sure the ice maker manual shutoff
slide is in the "ON" (open) position on the
infrared receiver module.
Manual Shutoff
Slide
4.
Close the freezer door for a minimum of 10
seconds.
5.
6.
7.
Infrared Receiver
Sensor
If you observe two LED pulses (flashes), per-
form the following steps.
1.
2.
3.
4.
5-2
Open the freezer door and activate the
freezer door switch 3 times. NOTE: This
step must be completed within 10 sec-
onds of opening the freezer door.
Close the freezer door within 20 seconds
of completing step 5.
Wait for a minimum of 5 seconds, and a
maximum of 50 seconds, then open the
freezer door and view the status LED on
the infrared receiver module for the error
code. NOTE: You will have 60 seconds to
open the freezer door, and 2 seconds from
then to view the LED output code.
Open the freezer door and remove the ice
bin from the door.
Make sure the ice maker manual shutoff
slide is in the "on" (open) position.
Tape the spring-loaded emitter door to the
emitter cover in the "down" position.
Close the freezer door for at least 10
seconds.
Freezer Door
Light Switch
Status LED