Whirlpool 6ED22DQXFB01 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Холодильник Whirlpool 6ED22DQXFB01. Whirlpool 6ED22DQXFB01 36 страниц. Side by side
WHIRLPOOL CONSUMER SERVICES
Models 6ED22DQXFW00 6ED22DQXFB01 6ED22DQXFW01
12. Remove the air pot by sliding by sliding the rear of the air pot out of the slot moulded to the dispenser housing
and slip the linkage out of the flapper door mechanism assembly.
13. Unsnap the flapper door and remove it from the ice dispenser lever. While you remove the flapper door,
carefully guide the flapper door heater wire and connector over the door mechanism assembly.
14. Remove the 1/4" hex head screw securing the dispenser levers pivot retainer to the dispenser housing and
remove the retainer.
15. Remove the water dispenser lever.
16. Remove the ice dispenser lever by maneuvering it around the door mechanism assembly.
17. Pull the pin from the door mechanism assembly and remove the spring and mechanism assembly
18. Re-assemble in the reverse order.
ICE CHUTE FLAPPER DOOR MOISTURE CONTROL
The ice chute flapper door has an inbuilt heating element which is not connected when delivered to the customer. In
extreme circumstances depending on installed position in kitchen or due to extreme humidity conditions, it may be
necessary to connect the heater to control excessive moisture.
To connect the flapper door heater:
1.
Unplug the refrigerator power cord.
2.
Remove the overflow grille from its housing.
3.
Unsnap the front cover at the bottom of the housing (See Figure 1).
4.
Plug the ribbon cable from the door to the door heater connector. (See Figure 2)
6ED22DQXFB02 6ED22DQXFW02
6ED22DQXFB03 6ED22DQXFW03
Page 5 of 36