Whirlpool WUR35X24HZ Руководство по эксплуатации и уходу - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Холодильник Whirlpool WUR35X24HZ. Whirlpool WUR35X24HZ 36 страниц. Under counter refrigerator
Также для Whirlpool WUR35X24HZ: Руководство по эксплуатации и уходу (36 страниц)
When Moving Your Beverage Center:
Your Beverage Center is heavy. When moving the Beverage
Center for cleaning or service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the Beverage Center straight out when moving it. Do not
wiggle or "walk" the Beverage Center when trying to move it,
as floor damage could occur.
Clean Before Using
After you remove all of the package materials, clean the inside
of your beverage center before using it. See the cleaning
instructions in "Beverage Center Care."
Important information to know about glass shelves and
covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
Reverse Door Swing (optional)
Tools Needed: Phillips screwdriver
1.
Unplug beverage center or disconnect power.
2.
Remove the screws from each side of the top of the
beverage center cabinet and set aside.
NOTE: There are seven screws total. Do not discard.
3.
Remove the hinge cover and washer and set aside.
Top View
A
A. Top of beverage center cabinet
B. Hinge cover
C. Washer
4.
Lift the door straight up and off of the bottom hinge.
5.
Remove the screws fastening the bottom hinge and
cover to the bottom of the beverage center cabinet.
There are five screws total.
6.
Move the bottom hinge and cover each to the opposite
side of the bottom of the beverage center cabinet.
Completely tighten the five screws.
B
C
Front View
A
A. Cover
B. Bottom of beverage
center cabinet
7.
Remove the two screws fastening the door stop spacer and
the door stop to the bottom of the beverage center door.
8.
Move the door stop spacer and the door stop to the
opposite side and fasten with the two screws. Completely
tighten the screws.
Bottom View
A. Bottom of beverage center door
B. Door stop spacer
C. Door stop
9.
Place the washer onto the bottom hinge, then install the
beverage center door onto the washer and hinge pin.
A
B
A. Bottom hinge washer
B. Bottom hinge
10. Align the top hinge washer with the hinge hole in the top of
the door. Then, insert the top hinge pin through the washer
and into the hinge hole.
11. Fasten the top hinge cover with three screws and move
the remaining four screws to the opposite side. Completely
tighten the seven screws.
A
B
A. Top hinge washer
B. Top hinge
B
C
D
C. Bottom hinge
D. Washer
A
B
C
5