Clam EDGE Руководство по эксплуатации и запчастям - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и запчастям для Газонное и садовое оборудование Clam EDGE. Clam EDGE 8 страниц. Power augers
Печатать страницу
Starting your Edge Auger
1. Press the fuel primer bulb between 5 and 8 times-or until
you see fuel returning in the fuel line. (Button on the right in
bubble)
2. Push in the decompression button. (Button on the left)
3. Position the choke lever to the "Start" position. (shown in
"Run" position)
4. Pull the recoil handle in short, fast pulls. If your Edge auger doesn't start on the first pull, you will need to
push in the decompression button again. Note: each time you pull on the recoil handle to start the engine,
you will need to reset the decompression button.
5. Repeat step 4 until engine starts. Once running, position the choke lever to the "Run" position and for best
performance, allow the auger's engine to run at idle for 1-2 minutes before drilling.
Note: Edge auger might be harder to start in extreme cold as all engines can be a little harder in very cold
temperatures. Under these very cold conditions you might want to apply a little pressure to the throttle
lever to aid in the starting process. In warmer conditions this shouldn't be necessary.
In the event your engine becomes flooded and won't start, you will need to remove and clean the
spark plug.-Removing the spark plug is covered in the "Maintenance" section of this manual.
Once the spark plug is removed, apply full throttle to the throttle lever and pull the recoil handle a
couple times to clear the combustion chamber.
Replace the spark plug and cap, keep the throttle lever in "Idle" position or without applied force,
and start the engine with the choke lever in the "Run" position.
6. To turn off your Edge auger once it's running, simply push the momentary stop switch found on the throttle
lever assembly. Doesn't get any easier...
Note: In the event your stop switch fails, position choke lever
to "Start" position and allow engine to shut off. Bring your
auger to an authorized service center for immediate
attention.
5