Whirlpool  WED97HEXW Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Сушилка Whirlpool  WED97HEXW. Whirlpool  WED97HEXW 24 страницы. Electronic dryer
Также для Whirlpool  WED97HEXW: Руководство по эксплуатации (8 страниц), Руководство по эксплуатации и уходу (36 страниц)

Whirlpool  WED97HEXW Руководство пользователя

ToolS AnD PARTS

Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver
Wire stripper (direct wire
installations)
1/4" and 5/16" nut driver
(recommended)
Utility knife
Level
Caulking gun and
compound (for installing
new exhaust vent)
® TORX is a registered trademark of Saturn Fasteners, Inc.

INSTALLATION REQUIREMENTS

#2 Phillips screwdriver
Tin snips (new vent
installations)
Adjustable wrench that
opens to 1" (25mm) or
hex-head socket wrench
Tape measure
Pliers
Min. 8" long Torx
T25
®
screwdriver
(for door reversal only)
Parts needed:
(Not supplied with dryer)
Vent clamps
Vent elbows and ductwork
Additional parts may be required, depending in your installation.
Check local codes. Check existing electrical supply and venting.
Read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL listed 30-amp power supply cord, rated 120/240 volt
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
A UL listed strain relief.
Parts supplied:
Parts package is located in dryer drum. Check that all parts
are included.
noTE: Do not use leveling legs supplied if installing with a
pedestal or a stack kit.
Leveling legs (4)
Short inlet hose
Rubber washer
optional Equipment:
(Not supplied with dryer)
Refer to your Use and Care Guide for information about
accessories available for your dryer.
"Y" connector
Long inlet hose
3