Whirlpool 3RLEC8600 Руководство по установке - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке для Сушилка Whirlpool 3RLEC8600. Whirlpool 3RLEC8600 8 страниц. Electric and gas dryers
Также для Whirlpool 3RLEC8600: Руководство по эксплуатации и уходу (12 страниц), Руководство по установке (8 страниц), Руководство по установке (8 страниц), Руководство по эксплуатации и уходу (12 страниц)

1. Install exhaust hood. Use sealing compound to seal exterior

wall opening around exhaust hood.

2. Connect vent to exhaust hood. Vent must fit inside exhaust

hood. Secure vent to exhaust hood with 102 mm (4") clamp.

3. Run vent to dryer location. Use the straightest path possible.

See "Vent Length Chart." Avoid 90º turns. Use 102 mm (4")

clamps to seal all joints. Do not use duct tape, screws, or

other fastening devices that extend into the interior of the vent

to secure the vent, because they can catch lint.

1. Open dryer door and remove drying rack, if included. Wipe

drum with damp cloth to remove any dust.

2. Take two cardboard corners from the dryer carton and place

them on the floor in back of the dryer. Firmly grasp body of the

dryer and gently lay it on its back on the cardboard corners.

3. Start to screw legs into holes by hand. Use an adjustable

wrench or 25 mm (1") hex-head socket wrench to finish

turning legs until you reach the ridge with the diamond

marking.

diamond

marking

4. To protect the floor, use a large at piece of cardboard from the

dryer carton. Stand dryer up on the cardboard.

INSTALLATION INSTRUCTIONS

This is a three wire dryer which must be earthed.

This dryer is supplied without an electric cord and plug; it

must be connected by a competent electrician. See "Electrical

Requirements."

1. Move dryer close to its permanent location. Leave enough

room to connect the exhaust vent. Remove the cardboard

from under the dryer.

2. Check levelness of dryer by placing a level on top of dryer,

first side to side, then front to back.

If dryer is not level, use a wrench to adjust dryer legs up or down

and recheck for levelness.

The dryer must be level to reduce noise and assure proper

performance.