Whirlpool 7570 Руководство по эксплуатации - Страница 13
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сушилка Whirlpool 7570. Whirlpool 7570 13 страниц. 7kg condenser tumble dryer with 6th sense , white azb 7570
Печатать страницу
- 1. Table of Contents
- 2. Before Using the Dryer
- 3. Precautions and General Recommendations
- 4. Electrical Connection
- 5. Description of the Dryer
- 6. Reminder - Maintenance and Cleaning
- 7. Cleaning the Lint Filter
- 8. Cleaning the Heat Exchanger
- 9. Drainage System
- 10. Door Reversibility
- 11. Troubleshooting Guide/ After-Sales Service
TROUBLESHOOTING GUIDE/
AFTER-SALES SERVICE
If a fault occurs, before contacting our After-
Sales Service, perform the following checks to
try to remedy the problem:
Drying takes too long / laundry is not dry
enough:
• Correct programme selected?
• Laundry too wet (Washing machine spin speed less
than 1000 rpm? When the spin speed is less than
1000 rpm a water container fault may occur during
the drying cycle).
• Lint filter clogged (filter indicator lamp on?)
• Heat exchanger clogged? (refer to the sections
"CLEANING THE LINT FILTER/CLEANING THE
HEAT EXCHANGER").
• Is the ambient temperature too high?
• END indicator lamps on? The drying cycle is
complete and the laundry can be taken out.
• 'Gentle' option selected? The 'Gentle' option should
only be selected with small loads.
• Mixed laundry load (for example cotton and
synthetics).
The dryer does not operate:
(after a power failure and/or interruption to the
mains supply, always press the "Start (Pause)"
button).
• Plug connector properly inserted into the mains
electricity socket?
• Power failure?
• Fuse blown?
• Door properly closed?
• Drying programme selected?
• Start delay option selected?
• "Start (Pause)" button activated?
• Indicator lamps are lighting up?
Lint filter, water container or heat exchanger
indicator lamp on:
• Lint filter clean?
• Water container empty?
• Water container correctly positioned?
• Heat exchanger clean and correctly positioned?
Water droplets underneath the dryer:
• Heat exchanger correctly positioned?
• All lint on the heat exchanger seal removed?
• All lint on the door seal removed?
• Water container positioned correctly?
• Dryer levelled?
After-Sales Service
If, after carrying out the above checks, the
malfunction persists or reoccurs, turn the
dryer off and call the After-Sales Service
(refer to warranty).
Please specify:
• The nature of the fault.
• The dryer type and model.
• The service code (the number after the word Service
on the adhesive rating plate) on the lower side of the
door opening.
• Your full address and phone number.
13