Whirlpool 8565592B Руководство по эксплуатации и уходу - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Сушилка Whirlpool 8565592B. Whirlpool 8565592B 20 страниц. 240-volt electric dryer

Печатать страницу

6. Replace strain relief (with power cord inserted) back into the

terminal block cover. Do not tighten strain relief nut.

A. Terminal block cover

B. Strain relief

C. Strain relief nut

D. Power cord

7. Now complete installation following instructions for your type

of electrical connection:

4-wire (recommended)

3-wire (if 4-wire is not available)

Electrical Connection Options

If your home has:

And you will be

connecting to:

4-wire receptacle

A UL listed,

(NEMA Type 14-30R)

120/240-volt

minimum,

30-amp, dryer

power supply

cord

4-wire direct

A fused

disconnect or

circuit breaker

box

(12.7 cm)

3-wire receptacle

A UL listed,

(NEMA type 10-30R)

120/240-volt

minimum,

30-amp, dryer

power supply

cord

3-wire direct

A fused

disconnect or

circuit breaker

box

3 "

(8.9 cm)

4-wire connection: Power supply cord

1. Locate the neutral ground wire inside the dryer cabinet,

Go to section

2. Connect ground wire (green or bare) of power supply cord to

4-wire connection:

3. Connect neutral wire (white or center wire) of power supply

Power supply cord

4-wire connection:

Direct Wire

3-wire connection:

Power supply cord

4. Connect the other wires to outer terminal block screws.

3-wire connection:

5. Replace the terminal block cover on the back of the dryer.

Direct Wire

6. Tighten strain relief nut.

4-wire connection: Direct Wire

Direct wire cable must have 5 ft (1.52 m) of extra length so dryer

can be moved if needed.

Strip 5" (12.7 cm) of outer covering from end of cable, leaving

bare ground wire at 5" (12.7 cm). Cut 1 " (3.8 cm) from

3 remaining wires. Strip insulation back 1" (2.5 cm). Shape ends

of wires into a hook shape.

A. 4-wire receptacle (NEMA type 14-30R)

B. 4-prong plug

C. Ground prong

D. Neutral prong

E. Spade terminals with upturned ends

F. Ring terminals

behind the external ground conductor screw. Remove this

wire.

A. Remove neutral ground wire.

external ground conductor screw. Tighten screw.

cord under center screw of the terminal block.

A. Neutral wire (white or center wire)

B. Center terminal block screw

C. External ground conductor screw

D. Ground wire (green or bare) of power supply cord

Tighten screws.