Whirlpool AED4475TQ1 Инструкции пользователя - Страница 10
Просмотреть онлайн или скачать pdf Инструкции пользователя для Сушилка Whirlpool AED4475TQ1. Whirlpool AED4475TQ1 24 страницы.
Печатать страницу
Is the dryer located in a closet?
■
Closet doors must have ventilation openings at the top and
bottom of the door. Sides and front of dryer require a minimum
of 1" (25 mm) of airspace, and the rear of the dryer requires
5" (127 mm). See the Installation Instructions.
Has an air dry cycle been selected?
■
Select the right cycle for the types of garments being dried.
Is the load too large and heavy to dry quickly?
■
Separate the load to tumble freely.
Cycle time too short
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
Is the automatic cycle ending early?
■
The load may not be contacting the sensor strips. Level
the dryer.
Change the dryness level setting on Automatic Cycles.
Increasing or decreasing the dryness level will change
the amount of drying time in a cycle.
Lint on load
Is the lint screen clogged?
■
Lint screen should be cleaned before each load.
Stains on load or drum
Was the dryer fabric softener properly used?
■
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
■
This will not transfer to other clothing.
Loads are wrinkled
Was the load removed from dryer at the end of
■
the cycle?
Was the dryer overloaded?
■
Dry smaller loads that can tumble freely.
10
Odors
Have you recently been painting, staining, or
■
varnishing in the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash, and dry the clothing.
Is the electric dryer being used for the first time?
■
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
Load is too hot
Were laundry items removed from the dryer before the end
■
of the cycle?
Allow the Cool Down cycle to finish before removing laundry
from dryer. All cycles are cooled slowly to reduced wrinkling
and make it easier to handle. Items removed before Cool Down
may feel very warm.
Was a high temperature cycle used, or was a separate
■
temperature control set on high?
Select a lower temperature, and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
Accessories
Enhance your dryer with these premium accessories.
For more high-quality items or to order, call 1-800-901-2042,
or visit us at www.applianceaccessories.com. In Canada, call
1-800-807-6777 or visit us at www.whirlpoolparts.ca.
Part Number
3404351
Drying rack - fits 29" (737 mm) Super Capacity,
6.5 cu. ft. (0.18 cu. m) - side swing or hamper
door
3406839
Drying rack - fits 29" (737 mm) Super Capacity
Plus, 7.0 cu. ft. (0.20 cu. m) - side swing door
only
Accessory