Whirlpool Cabrio,- WED7300X Руководство по эксплуатации и уходу - Страница 10

Печатать страницу

Whirlpool Cabrio,- WED7300X Руководство по эксплуатации и уходу

ADDITIONAL FEATURES

USING THE DRYING RACK

To obtain a drying rack for your dryer, follow the instructions

included in your dryer drum. Remove and discard any

packing material before use.

Use the Drying Rack for items that you do not want to

tumble dry, such as sweaters and tennis shoes. When you

use the drying rack, the drum continues to turn, but the rack

remains stationary.

The drying rack is intended for use with the Timed Dry

Cycles only. The drying rack cannot be used with any

Automatic Cycles.

To use the drying rack:

IMPORTANT: Do not remove the lint screen.

1. Open dryer door.

2. Align the two hooks on the front of the drying rack with

the holes in the dryer door opening and press down fully

into holes. Rest the rear support on the dryer back ledge.

3. Place wet items on top of the drying rack. Allow space

around items for air to circulate. The drying rack does

not move, but the drum will rotate; be sure to leave

adequate clearance between items and the inside

of the dryer drum. Make sure items do not hang over

the edges or between drying rack grille.

4. Close the door.

5. Select Timed Dry. Select the Air Only, Low or Extra Low

Temp setting. Items containing foam, rubber, or plastic

must be dried on a clothesline or by using the Air Only

Temp setting.

6. When the cycle is selected, the Estimated Time

Remaining display shows the default time. You can

change the actual time in the cycle by increasing or

decreasing the cycle time.

7. Press START/PAUSE.

NOTE: Check the lint screen and remove any lint

accumulated from items dried on the drying rack

after the cycle is finished.

CHANGING THE DRUM LIGHT

The dryer light automatically turns on inside the dryer drum

when you open the door.

To change the drum light:

1. Unplug dryer or disconnect power.

2. Open the dryer door. Locate the light bulb cover on the

back wall of the dryer. Remove the screw located in the

lower right corner of the cover. Remove the cover.

3. Turn bulb counterclockwise. Replace the bulb with

a 10-watt appliance bulb only. Replace the cover and

secure with the screw.

4. Plug in dryer or reconnect power.