Whirlpool Cabrio,- WED7300X Руководство по эксплуатации и уходу - Страница 14

Печатать страницу

Whirlpool Cabrio,- WED7300X Руководство по эксплуатации и уходу

Troubleshooting

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help -

If you experience

Vibration or Off-Balance

Vibration, rocking, or

"walking"

Vibration during spinning

or washer stopped with

all dial lights ashing

Noises – For normal operating sounds, go to www.whirlpool.com/product_help.

Clicking or metallic

noises

Gurgling or humming

Humming

Whirring

Water Leaks

Check the following for

proper installation:

Washer not performing as expected

Not enough water

in washer

Washer won't run or ll,

washer stops working

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.

Possible Causes

Feet may not be in contact with the

oor and locked.

Washer may not be level.

Load could be unbalanced.

Objects may be caught in washer

drain system.

Washer may be draining water.

Load sensing may be occurring.

Basket deceleration may be

occurring.

Washer not level.

Fill hoses not attached tightly.

Fill hose washers

Drain hose connection

Check household plumbing for leaks

or clogged sink or drain.

Washer not loaded as

recommended.

Load not completely covered

in water.

Check for proper water supply.

Front and rear feet must be in rm contact with oor, and washer

must be level to operate properly.

Check oor for exing or sagging. If ooring is uneven, a 3/4"

(19 mm) piece of plywood under your washer will reduce sound.

See "Level the Washer" in the Installation Instructions.

Load items in loose heaps evenly around the washplate. Adding

wet items to washer or adding more water to basket could

unbalance washer.

Avoid washing single items. Balance a single item such as a

rug or jeans jacket with a few extra items. If the dial is ashing,

redistribute the load, close the lid, and press START/PAUSE.

Use Bulky/Sheets Deep Water Wash cycle for oversized, non-

absorbent items such as comforters or poly- lled jackets. Other

items are not appropriate for Bulky/Sheets Normal cycle. See

"Cycle Guide."

Item or load not suitable for selected cycle. See "Cycle Guide"

and "Using Your Washer."

Empty pockets before washing. Loose items such as coins

could fall between basket and tub or may block pump. It may be

necessary to call for service to remove items.

It is normal to hear metal items on clothing such as metal snaps,

buckles, or zippers touch against the stainless steel basket.

It is normal to hear the pump making a continuous humming

sound with periodic gurgling or surging as nal amounts of water

are removed during the spin/drain cycles.

You may hear the hum of the sensing spins after you have

started the washer. This is normal.

You may hear the whirring sound of the basket decelerating.

This is normal.

Water may splash off basket if washer is not level.

Tighten ll-hose connection.

Make sure all four ll hose at washers are properly seated.

Pull drain hose from washer cabinet and properly secure it to

drainpipe or laundry tub.

Do not place tape over drain opening.

Water can back up out of a clogged sink or drainpipe. Check all

household plumbing for leaks (laundry tubs, drain pipe, water

pipes, and faucets.)

An unbalanced load can cause basket to be out of alignment

and cause water to splash off tub. See "Using Your Washer" for

loading instructions.

This is normal operation for an HE low-water washer. The load

will not be completely underwater. The washer senses load

sizes and adds correct amount of water for optimal cleaning.

See "What's New under the Lid."

IMPORTANT: Do not add more water to washer. Adding water lifts

the items off the washplate, resulting in less effective cleaning.

Both hoses must be attached and have water owing to inlet valve.

Both hot and cold water faucets must be turned on.

Check that inlet valve screens have not become clogged.

Check for any kinks in inlet hoses, which can restrict water ow.

Solution