Whirlpool Duet GEW9250PT0 Руководство по эксплуатации и уходу - Страница 12
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Сушилка Whirlpool Duet GEW9250PT0. Whirlpool Duet GEW9250PT0 24 страницы. Electronic electric dryer
Печатать страницуFire Hazard
Use a heavy metaB vent.
De net use a pmasticvent.
De net use a metam foil vent.
Failure to fellow
these instructions
can result in death
or fire.
WARNING;
To reduce the risk of fire, this dryer MUST BE
EXHAUSTED OUTDOORS.
4" (10.2 cm) heavy metal exhaust vent and clamps must be used.
DURASAFF Mvent products are recommended.
DURASAFF Mvent products can be purchased from your dealer
or by calling Whirlpool Parts and Accessories.
For more
information, see the "Assistance
or Service" section of this
manual.
•
The dryer exhaust must not be connected
into any gas vent,
chimney, wall, ceiling, or a concealed
space of a building.
•
Do not use an exhaust hood with a magnetic latch.
•
Do not install flexible metal vent in enclosed walls, ceilings or
floors.
Use clamps to seal all joints. Exhaust vent must not be
connected or secured with screws or other fastening devices
which extend into the interior of the duct. Do not use duct
tape.
IMPORTANT: Observe all governing codes and ordinances.
improper
venting
can cause moisture
and lint to collect
indoors, which
may resumt in:
[]
Moisture damage to woodwork,
furniture, paint,
wa!lpaper, carpets, etc.
[]
Housecleaning
probIems and health problems=
Use a heavy metal vent. Do not use plastic or metal foil vent.
Rigid metal vent is recommended
to prevent crushing and
kinking.
Flexible metal vent must be fully extended and supported when
the dryer is in its final position. Remove excess flexible metal vent
to avoid sagging and kinking that can result in reduced airflow
and poor performance.
An exhaust hood should cap the vent to prevent rodents and
insects from entering the home.
Exhaust hood must be at least 12" (30.5 cm) from the ground or
any object that is in the path of the exhaust (such as flowers,
rocks or bushes, etc.).
If using an existing vent system, clean lint from the entire length
of the system and make sure exhaust hood is not plugged with
lint. Replace any plastic or metal foil vent with rigid metal or
flexible metal vent.
Typical exhaust
installations
Typical installations vent the dryer from the rear of the dryer.
Other installations are possible.
H
A. Dryer
B. Elbow
C. Wall
D. Exhaust hood
E. Clamps
E Rigid metal or flexible metal vent
G. Vent length necessary to connect elbows
H. Exhaust outlet
Optional
exhaust installations
This dryer can be converted to exhaust out the right side, left
side, or through the bottom. Contact your local dealer to have the
dryer converted.
Fire Hazard
Cover unused exhaust
ho_es with one of the
following
kits:
279818 (white)
279925 (biscuit)
279969 (pewter)
Contact your mocat dealer.
FaiJure to follow
these instructions can resumt in death,
fire, electrical
shock, or serious
injury.
12