Whirlpool WHD5090GW Руководство по эксплуатации и уходу - Страница 32
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Сушилка Whirlpool WHD5090GW. Whirlpool WHD5090GW 35 страниц. Heat pump dryer
Печатать страницу
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –
If you experience
Dryer Displays Code Message or LED Symbol Lights Up
F01 to F04
F05 to F09
F10 to F24
32
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
Possible Causes
Water tank is filled with water.
Water tank is not correctly
positioned.
Bottom filter is blocked by lint.
Bottom filter is not correctly
positioned.
Door filter is blocked by lint.
Door filter is not correctly positioned.
A component has failed.
A component has failed.
A component has failed.
Empty water tank; make sure to insert it properly afterwards.
Push in the water tank to make sure that it is correctly inserted
in the tank compartment.
Clean the bottom filter; make sure to insert it properly afterwards.
Push in the bottom filter and move the release levers into
a vertical position to make sure the filter is correctly inserted
in the filter compartment. Close the flap.
Remove and clean the door filter; afterwards, make sure to insert
it properly in the filter compartment.
Check position of the door filter; make sure that it is properly
inserted in the filter compartment.
Touch and hold the Power button for at least 3 seconds while
dryer is on.
Turn off and unplug the dryer. Immediately open the door and
take out the laundry so that the heat can dissipate. Make sure
that the ambient temperature ranges between 41°F (5°C) and
95°F (35°C). After about one hour, plug in the dryer, load the
laundry, and start the program/cycle again. If the failure persists,
call for service.
Turn off and unplug the dryer. After about half an hour, plug
in the dryer and start the program/cycle again. If the failure
persists, call for service.
Solution