Whirlpool WTW7500GC Руководство по эксплуатации и уходу - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Сушилка Whirlpool WTW7500GC. Whirlpool WTW7500GC 48 страниц. Electronic dryer
Также для Whirlpool WTW7500GC: Руководство по установке (40 страниц), Руководство по эксплуатации и уходу (32 страниц)
Печатать страницу
Control Panel and Features
1
NOTE: The control panel features a sensitive surface that responds to a light touch of your finger. To ensure your selections are
registered, touch the control panel with your finger tip, not your fingernail. When selecting a setting or option, simply touch its name
until the desired section is illuminated.
POWER BUTTON
1
Touch to turn the washer on. Touching once while the washer
is on will cancel the current cycle, touching twice will turn
the washer off.
WHAT TO WASH/HOW TO WASH
2
First select a cycle from "What to Wash" and then select
"How to Wash" to get the best combination cycle available
for the type of items you are going to wash. See "Cycle
Guide" for cycle details.
START/PAUSE BUTTON
3
Touch and hold the START/PAUSE button to begin
the selected cycle; touch again to pause a cycle.
LED TIME/STATUS DISPLAY
4
The Estimated Time Remaining display shows the time
required for the cycle to complete. Factors such as load
size and water pressure may affect the time shown in
the display. Tightly packed loads, unbalanced loads, or
excessive suds may cause the washer to adjust the cycle
time, as well.
If you have set a delay start to the cycle, the Estimated
Time Remaining display will show the delay time adjusted.
When the cycle is complete, the Done indicator will light
until the lid is opened.
ADD GARMENT
When Add Garment is lit, you may pause the washer,
open the lid, and add items. Touch and hold the
START/PAUSE button to start the washer again.
OPTIONS
5
You may add or remove options for each cycle. Not all
options can be used with all cycles, and some are preset
to work with certain cycles.
EXTRA RINSE
This option can be used to automatically add a second
rinse to most cycles.
DRAIN & SPIN
This option spins the load and drains any water in the tub.
The load is not rinsed.
RINSE & SPIN
Touch the DRAIN & SPIN button, then touch the EXTRA
RINSE button. This option combines a rinse and high spin
2
5
4
6
speed for loads requiring an additional rinse cycle
or to complete a load after power interruption.
Also use for loads that require rinsing only.
CLEAN WASHER
Use this every 30 washes to keep the inside of your
washer fresh and clean. This cycle uses a higher water
level. Use with affresh
chlorine bleach to thoroughly clean the inside of your
washer. This cycle should not be interrupted. See
"Washer Care."
IMPORTANT: Do not place garments or other items in
the washer during the Clean Washer cycle. Use this cycle
with an empty washer tub.
SIGNAL
Use this to turn the signal indicating the end of a wash
cycle to low, high, or off.
NOTE: You may also adjust the tones that sound when
a feature, setting, or option is touched. Touch and hold
SIGNAL for about 3 seconds to turn key activation
sounds to low, high, or off.
DELAY START
Touch DELAY START to delay the start of the wash cycle
up to 12 hours "12H." Touch DELAY START until a "0H"
appears in the status display to turn off, or touch the
POWER button.
DEEP WATER
Use this option to add the maximum amount of water
to your wash cycle.
NOTE: Expect longer cycle times due to extended fill
times when using the Deep Water option.
PRESOAK
Use this option to add an extra soak period to any cycle
to help loosen tough stains. The washer will fill and pause
to soak, then begin the selected cycle.
CYCLE MODIFIERS
6
When you select a cycle, its default settings or the previous
cycle selection used will light up.
TEMPERATURE
Temperature Control senses and maintains uniform
water temperatures by regulating incoming hot and
cold water.
3
5
7
Washer Cleaner tablet or liquid
®
5