Whirlpool YWED94HEAC Руководство по установке - Страница 9

Просмотреть онлайн или скачать pdf Руководство по установке для Сушилка Whirlpool YWED94HEAC. Whirlpool YWED94HEAC 22 страницы. Gas dryer

INSTALL LEVELING LEGS

Prepare dryer for leveling legs

To avoid damaging floor, use a large flat piece of cardboard

from dryer carton; place under entire back edge of dryer.

Firmly grasp dryer body (not console panel) and gently lay

dryer down on cardboard.

Screw in leveling legs

diamond

marking

Examine leveling legs, find diamond marking. Screw legs into

leg holes by hand – use a wrench to finish turning legs until

diamond marking is no longer visible.

Place a carton corner post from dryer packaging under each

of the 2 dryer back corners. Stand the dryer up. Slide the

dryer on the corner posts until it is close to its final location.

Leave enough room to connect the exhaust vent.

Connect gas supply to dryer

A. Flared male fitting

B. Non-flared male fitting

Remove red cap from gas pipe. Using a wrench to tighten,

connect gas supply to dryer. Use pipe-joint compound

on threads of all non-flared male fittings. If flexible metal

tubing is used, be sure there are no kinks.

NOTE: For LP gas connections, you must use pipe-joint

compound resistant to action of LP gas Do not use

TEFLON

tape.

Plan pipe fitting connection (option 1)

A. 3/8" flexible gas connector

B. 3/8" dryer gas pipe

A combination of pipe fittings must be used to connect dryer

to existing gas line. A recommended connection is shown.

Your connection may be different, according to supply line

type, size, and location.

Open shut-off valve

A. Closed valve

B. Open valve

Open shut-off valve in supply line; valve is open when handle

is parallel to gas pipe. Then, test all connections by brushing

on an approved noncorrosive leak-detection solution.

Bubbles will show a leak. Correct any leak found.

C. 3/8" to 3/8" pipe elbow

D. 3/8" pipe-to-flare adapter

fitting