Calandra Racing Concepts Battle Axe 2.0 Руководство по сборке - Страница 9

Просмотреть онлайн или скачать pdf Руководство по сборке для Игрушечный автомобиль с мотором Calandra Racing Concepts Battle Axe 2.0. Calandra Racing Concepts Battle Axe 2.0 16 страниц. 1:10th oval weapon from team crc

Печатать страницу

CRC Pro-Strut

Front End - cont.

1 - Push the Dual aluminum axle [45] into the plastic steering block [42]. Push it all the way

in firmly. Notice you can install the axle inline or trailing. Typically, this is installed inline for

1/10th racing. This will increase the steering response as compared to trailing.

2 - Insert the e-clip [48] into the groove on the end of the King pin [46]. Next, slide the nylon

spring cup [50] all the way down until it rests against the e-clip. Make sure the larger

diameter of the spring cup is against the e-clip and the smaller diameter side faces up. Now

slide the spring [47] down against the spring cup, large side down. The larger end of the

spring will fit over the step in the spring cup, and the smaller end of the spring will fit into the

bottom of the lower arm.

3 - Now put your king pin / spring assembly on the end of the Allen key and slide it through

the lower arm pivot ball [30], & then thread it into the steering block (with the steering block

all the way down against the pivot ball). Thread the king pin in until the spring just touches

the lower arm pivot ball. The preload on the spring can be adjusted with the king pin length.

4 - Once happy with the preload position, lock the king pin with the 4-40 brass set screw

[49] through the back of the steering block.

4-40 x 1/4"

Red Low-

Red Button Head

Profile Ball

Red

Side Spring

1 - Build up the left and right steering blocks [42] as shown to the left. Start by threading the red button head screw

[22] through the graphite steering arm [43] and into the red low profile ball [12].

2 - Then, slide the graphite steering arm assembly into the steering block, lining up the 2 mounting holes. Using the

black 2-56 socket head screws [44], fasten the arm to the steering block. DO NOT OVER tighten. You will drive the

screw through the steering block, deforming the part.

Graphite

2-56 SH

Steering Arm

E-Clip

Nylon Spring

Cup

1 - Take the upper pivot ball [51] and push it though the steering block and

thread into the upper arm. Thread it in so there are no threads showing.

2 - Take the slotted capture insert [52] and thread it into the steering block.

THIS IS A BIT TRICKY .... as the insert must be fitted at a down angle as

shown to the left. DO NOT try to insert it horizontally into the steering block. It

is actually threaded in at a down angle toward the center of the car.

3 - Tighten this capture insert so that the steering movement is bound and

slow. Yes, we are actually slightly over tightening this piece FOR NOW. With

the steering movement bound from over tightening, move the steering to it's

limits, back and forth. What we are doing is "breaking in" the upper

ball/capture insert. After a minute or so of break in, loosen the insert just

enough so the steering is free. Not too much or you will induce excessive free

play.

Dual Axle

Upper

Brass Set

Ball

Screw

King Pin