Whirlpool 30 " Eye-Level Gas Range Инструкции по установке и руководство по эксплуатации и уходу - Страница 10

Печатать страницу

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

The hood controls are located on the front panel of the range

hood.

A. Incandescent light housing and cover

B. Grease filter retainer

C. Grease filter

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace the grease filter

before operating hood.

Exterior Surfaces:

IMPORTANT: Do not use soap-filled scouring pads, abrasive

cleaners, cooktop polishing creme, steel wool, gritty washcloths

or paper towels.

To avoid damage to the stainless steel, do not use cleaners that

contain chlorine.

Cleaning Method:

Liquid detergent or all-purpose cleaner:

Rinse with clean water and dry with a soft, lint-free cloth.

Glass cleaner to remove fingerprints.

For stainless steel models, use Stainless Steel Cleaner

and Polish, Part Number 31462A (not included): See

the "Assistance or Service" section to order.

For stainless steel models, rub in the direction of the grain to

avoid scratching or damaging the surface.

RANGE HOOD USE

RANGE HOOD CARE

Range Hood Controls

Operating the light

Turn the light switch to the right 1 position for Low (night light).

Turn the light switch to the right 2 positions for High.

Operating the fan

The fan is variable speed. Rotate the fan switch to the right to

turn the fan to the On position. Continue to rotate the switch to

the desired fan speed.

To turn the fan off, rotate the fan speed switch to the left to the

Off position.

Cleaning

Metal or Charcoal Grease Filter

To Clean the Filter:

1. Remove the screw from the grease filter retainer.

2. Turn the grease filter retainer to release the filter.

3. For vented installations: Wash the metal filter as needed in a

dishwasher or hot detergent solution.

For non-vented (recirculating) installations: Replace the

metal filter with a charcoal filter. The charcoal filter is not

washable. It should last up to 6 months with normal use. For

information on ordering, see the "Assistance or Service"

section. Dispose of old charcoal filter.

To Replace the Filter:

1. To reinstall the filter, place the back edge of the filter into the

channel at the rear of the hood. Push the filter into place and

turn the filter retainer to secure the filter to the range hood.

2. Replace the screw in the grease filter retainer.

A. Fan speed switch

B. On/Off light switch

A. Filter retainer