FirePro FPC-2V2 Руководство по эксплуатации и установке - Страница 12
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и установке для Контроллер FirePro FPC-2V2. FirePro FPC-2V2 19 страниц. Fire extinguishant controller
Печатать страницу
ALL TECHNICAL CHECKS MUST COMPLY WITH APPLICABLE
LOCAL CODES, REGULATIONS AND SPECIFIC PROJECT
4.1 System Test
Step 1
Step 2
Step 3
Step 4
Step 5
4.2 Release Test
Step 6
Step 7
Step 8
Step 9
Step 10
4.3 Detector monitoring Test
Step 11
Step 12
Step 13
Man-1556 Rev.02
FPC-2V2 Fire Extinguishant Controller Operation and Installation Manual
Power off the unit.
Turn Isolate Key Switch to "Off" position.
Disconnect the FirePro Generators and ensure that the test lamps are
fitted to the terminals.
Ensure both jumper links (J1 & J2) are fitted in position A
Inspect all system components (Detectors, Sirens etc.) and all cables for
signs of damage.
Power on the unit.
Turn Isolate Key Switch to "Live" position.
Trigger the detection input by operating a smoke detector or linear heat
detector.
Ensure both jumper links (J1 & J2) are fitted in position A
Inspect all system components (Detectors, Sirens etc.) and all cables for
signs of damage.
Disconnect the wiring to the detector and ensure that the yellow Fault LED
on the front panel and the internal yellow LED marked LED4 are lit and the
buzzer sounds.
Press the Silence Buzzer button and ensure the buzzer silences.
Re-connect the detector wiring and ensure that the fault indications clear.
IMPORTANT
REQUIREMENTS
Page 12 of 18