Whirlpool Build-in 30 inch Инструкции по установке и руководство по эксплуатации и уходу - Страница 4
Просмотреть онлайн или скачать pdf Инструкции по установке и руководство по эксплуатации и уходу для Вентиляционная вытяжка Whirlpool Build-in 30 inch. Whirlpool Build-in 30 inch 24 страницы. 30" electric built-in cooktop with glass-ceramic smooth top
Также для Whirlpool Build-in 30 inch: Руководство по установке (8 страниц)
Печатать страницу
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Level
Drill
1¹⁄₄" drill bit
¹⁄₈" (3 mm) drill bit for pilot holes
Pencil
Pliers
Wire stripper or utility knife
Tape measure or ruler
Caulking gun and weatherproof caulking compound
Phillips screwdriver
Saber or keyhole saw
Vent clamps
Metal snips
Compass or 7" (17.8 cm) circle template
Parts supplied
Check that all parts are included.
Hardware package (1)
7" (17.8 cm) round damper
Parts needed
UL listed or CSA approved ¹⁄₂" (12.5 mm) strain relief
75-watt max incandescent light bulb
Power supply cable
7" (17.8 cm) round metal venting
For cabinets with recessed bottoms:
2 - 2" (5.1 cm) wide filler strips. Length and thickness
determined by recess dimensions.
4 flat-head wood screws or machine screws with washers
and nuts to attach filler strips.
4
INSTALLATION REQUIREMENTS
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
It is the installer's responsibility to comply with installation
clearances specified on the model/serial rating plate. The
model/serial rating plate is located inside the range hood on
the rear wall.
Range hood location should be away from strong draft areas,
such as windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance. Consult the
cooktop/range manufacturer installation instructions before
making any cutouts.
Grounded electrical outlet is required. See "Electrical
Requirements" section.
The range hood is factory set for venting through the roof or
wall.
All openings in ceiling and wall where range hood will be
installed must be sealed.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local
codes.
Product Dimensions
⁷⁄₈"
29
(75.9 cm)
⁷⁄₈"
35
(91.1 cm)
2"
(5.1 cm)
⁵⁄₈"
17
(44.8 cm)
³/₄"
(19.1 cm)
Wiring knockouts
12"
(30.5 cm)
7" (17.8 cm)
Round vent
³⁄₄"
5
(14.6 cm)
Centerline
6"
(15.2 cm)
Rear of hood
Centerline
¹⁄₂"
7
(19.1 cm)