Whirlpool GZ5736XRT0 Инструкции по установке и руководство по эксплуатации и уходу - Страница 7
Просмотреть онлайн или скачать pdf Инструкции по установке и руководство по эксплуатации и уходу для Вентиляционная вытяжка Whirlpool GZ5736XRT0. Whirlpool GZ5736XRT0 24 страницы. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
Также для Whirlpool GZ5736XRT0: Руководство по эксплуатации (1 страниц)
Печатать страницу
2,
Remove tape holding standard filters in place. Remove both
fiiters, insert flat blade screwdriver into slots in filters. Push
each filter toward back of hood, lift out and set aside.
A
3,
,
B
A. Filterslots
B, Flatbladescrewdriver
Remove damper/vent
connector from inside the hood. Set
connector, mounting screws and parts bag aside.
A, Damper/vent c onnector
4, Remove wiring cover from inside the hood. Set cover and
mounting screw aside.
5,
A, Wiring cover
Depending on your installation, remove either top or back
wiring knockout and install a 1/,,,UL- or CSA-listed strain
relief.
A. Strain relief
For r_or_-vented
installations
Go to "Make EbctricaI Connection"
section.
For vented
installations
1, Remove the five screws holding the light panel in place and
set them aside.
2, Disconnect the light assembly wiring connector.
Make sure not to disconnect any wires.
3, Remove the light panel and set aside.
\
A \
5,
6,
7,
8,
A. Light panel
Remove
the air chute
hetd in place with one screw.
J
A, Air chute
Remove baffle from air chute.
A
A, Baffle
Rotate baffle and reinsert it back into the air chute so that the
baffle tabs fit all the way into the slots in the air baffle.This will
close off the air flow through the non-vented slots on top of
the hood.
B
A. Tab slots
B. Tabs
Replace air chute.
Connect light assembly wiring connector and replace light
panel.
NOTE: Make sure not to trap wires between the support fin
and light panel.