Whirlpool IH7302RS0 Инструкция по установке и руководство по эксплуатации и уходу - Страница 7
Просмотреть онлайн или скачать pdf Инструкция по установке и руководство по эксплуатации и уходу для Вентиляционная вытяжка Whirlpool IH7302RS0. Whirlpool IH7302RS0 28 страниц. 30" (76.2 cm) wall-mount canopy range hood
Печатать страницу
6. Tape template in place, aligning the template centerline and
bottom of template with hood bottom line and with the
centerline marked on the wall.
B
C
A. Centerline
B. Mounting hook location
C. Fastener locations
D. Mounting height reference
7. Mark centers of the 6 fastener locations through the template
to the wall.
IMPORTANT: At least two of the screws must be installed into
wood.
Remove the template.
8. Drill
" (2.75 mm) pilot holes at all locations where screws
are being installed into wood.
9. Determine and make all necessary cuts in the wall for the vent
system. Install the vent system before installing the hood. See
"Venting Requirements" section.
10. Determine the required height for the
1 " (3.2 cm) hole at this location.
11. Run wire through the
Electrical Code or CSA Standards and local codes and
ordinances. There must be enough
the fused disconnect (or circuit breaker) box to make the
connection in the hood's electrical terminal box.
12. Use caulk to seal all openings.
NOTE: Do not turn on power until installation is complete.
13. Attach 2 mounting hooks to the wall at locations marked on
the template.
A
A. Mounting hooks
B. Centerline on wall
A
B
" conduit and drill a
" conduit according to the National
" conduit and wires from
B
Vent Cover Bracket Installation
Installations using telescoping upper and lower vent cover
assembly.
1. Position vent cover bracket on wall about
from the ceiling.
2. Mark the hole locations.
3. Drill
flush with the wall.
4. Attach vent cover bracket to wall.
D
Installation locations with reduced ceiling heights.
The vent hood may be installed using only the lower vent
cover plus a
1. For the vent cover to slide down and engage the top of
the hood, the vent cover bracket must be mounted
(6.4 mm) below the ceiling.
2. The remaining space above the vent cover can be filled
with a
cross section of the chimney cover and finished to match
the ceiling.
3. Cut the self-adhesive rubber tape supplied with the hood
in 4 identical pieces. Attach two pieces of tape to each
side of the ceiling bracket.
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
1. Remove hood from carton and set on protected surface.
2. Tip range hood back and remove metal filters.
3. Hang hood on 2 mounting hooks through the rectangular
cutouts on back of hood.
" (9.5 mm) holes for wall anchors and insert anchors
B
A. Vent cover bracket
B. Centerline on wall
" (6.4 mm) thick wood filler.
" (6.4 mm) thick piece of plywood cut to the inside
A. Rubber tape
Install Range Hood
WARNING
Excessive Weight Hazard
" (3 mm) away
A
"
A
7