Whirlpool UMH50008HS0 Руководство по установке - Страница 4
Просмотреть онлайн или скачать pdf Руководство по установке для Вентиляционная вытяжка Whirlpool UMH50008HS0. Whirlpool UMH50008HS0 12 страниц. Microwave hood combination
Печатать страницу
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.
GROUNDING INSTRUCTIONS
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
4
Venting Requirements
This section is intended for architectural designer and
builder/contractor reference only.
NOTES:
If installing for recirculation, venting must be routed up and
out through an exhaust register (not provided) in a kitchen
soffit. A charcoal filter kit (not provided) should be used. See
"Assistance" section for information on ordering.
Vent materials needed for installation are not provided with
microwave hood combination.
We do not recommend using a flexible metal vent.
To avoid possible product damage, be sure to vent air
outside, unless using recirculation installation. Do not vent
exhaust air into concealed spaces, such as spaces within
walls or ceilings, attics, crawl spaces or garages.
For optimal venting installation, we recommend:
using roof or wall caps that have back draft dampers
using a rigid metal vent
using the most direct route by minimizing the length of the
vent and number of elbows to provide efficient performance
using uniformly sized vents
using duct tape to seal all joints in the vent system
using caulking compound to seal exterior wall or roof opening
around cap
for optimal hood performance, do not install 2 elbows
together
If rectangular to round transition is used, be sure there is at least
3" (7.6 cm) of clearance between the top of the damper assembly
and the transition piece. See "Rectangular to Round Transition"
illustration.
Recirculation venting
Roof venting
Wall venting
Exhaust register
Roof cap
Wall cap