Whirlpool UXD8630DYS0 Руководство по эксплуатации и уходу - Страница 15
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Вентиляционная вытяжка Whirlpool UXD8630DYS0. Whirlpool UXD8630DYS0 36 страниц. 30" and 36" retractable (pop-up) downdraft vent system
Печатать страницуTo Use:
1.
Push and hold the button
on top of downdraft
vent for a few
seconds,
(This slight delay helps avoid unintentional
raising
of
the vent during
cleaning
of the cooktop
area.) Retractable
section
of downdraft
vent will rise, Blower will begin to vent
immediately
if blower
control knob
slider is set to an "On"
position.
2.
Slide the control
slider on the right-hand
side of the
downdraft
vent to adjust the blower
motor speed.
When Cooking
Is Complete:
1. Push the button on top of the retractable downdraft vent. The
blower will turn off, and the retractable section of the vent will
return to the closed position.
NOTE: If a spill occurs on the cooktop that allows liquids to seep
inside the downdraft
vent, you must turn the downdraft vent off
immediately. It is possible to cause damage to the downdraft
vent if water is allowed inside the downdraft vent while it is
operating.
2. Immediately turn off the downdraft vent at the speed control
located on the right-hand side of the downdraft vent.
3. Turn off the power supply to the downdraft vent at the circuit
breaker box or fuse box.
4. Allow plenty of time for the downdraft vent to dry naturally. Do
not open the downdraft vent to remove the water.
VENTSYSTEM CARE
To avoid damaging the finish, clean downdraft vent with soap and water. Do not use scouring powder or abrasive solutions.
Exterior Surfaces:
•
To avoid damage to the exterior surface, do not use steel
wool or soap-filled
scouring pads.
•
Always wipe dry to avoid water marks.
Cleaning Method:
•
Liquid detergent soap and water, or all-purpose
cleanser
•
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Frequently remove and clean the filter(s) in the retractable section of the downdraft vent. This will improve the operating efficiency of the
downdraft vent system.
To Replace:
1. Remove each filter by pulling the spring release handle and
then pulling down the filter.
2. Wash metal filters as needed in dishwasher or hot detergent
solution.
3. Reinstall the filter by making sure the spring release handles
are toward the front. Insert metal grease filter into upper
track.
4. Pull the spring release handle down.
5. Push up on metal filter and release handle to latch into place.
6. Repeat steps 1-5 for the other filter.
To Clean:
1. Remove the filter(s) and clean them in a dishwasher
or in a
hot detergent solution. The downdraft vent will not operate
when the filters are not in place.
2. Dry the clean filter(s) and reinstall, making sure that they lock
into place.
If Retractable
Downdraft
Vent Does Not Operate After
Clean Filters Have Been Installed:
Push the filter in as far as it will go. When the filter is removed, the
microswitch
behind the filter is inactivated. This feature will not
allow the vent system to operate until the filter is properly
installed.
A
A. Spring release handles
B. Left metal filter
C. Right metal filter
15