Whirlpool UXT2036AYW0 Инструкции по установке и руководство по эксплуатации и уходу - Страница 9

Просмотреть онлайн или скачать pdf Инструкции по установке и руководство по эксплуатации и уходу для Вентиляционная вытяжка Whirlpool UXT2036AYW0. Whirlpool UXT2036AYW0 28 страниц. 30" (76.2 cm) and 36" (91.4 cm) range hood

Печатать страницу
2.
3.
Remove the screw from the terminal box cover. Remove
terminal box cover and set aside.
A. Terminal box cover
B. Screw
Remove the power supply knockout from the top or rear of
the vent hood (depending on the incoming location of your
home power supply cable) and install a UL listed or CSA
approved 1/2"strain relief.
A. Power supply knockout
4. Using 2 or more people, lift the hood into final position. Feed
enough electrical wire through the 1/2"UL listed or CSA
approved strain relief to make connections
in the terminal
box. Tighten the strain relief screws.
5. Position the range hood so that the large end of the keyhole
slots are over the mounting screws. Then push the hood
toward the wall so that the screws are in the neck of the slots.
Tighten the mounting screws, making sure the screws are in
the narrow neck of slots.
6. Connect ventwork to hood. Seal joints with vent clamps or
duct tape to make secure and airtight.
7. Check that back draft dampers work properly.
Mc <® E
ccl Connec
on
Electrical
Shock Hazard
Disconnect
power before servicing.
Replace all parts and panems before operating.
Failure to do so can resumt in death or electrical
shock.
1. Disconnect
power.
A
B
F
E
A. White wires
B. Black wires
C. UL listed wire connector
D. Green (or bare) ground wire
E. Home
power
supply
cable
or
power
cord
accessory
kit
F. UL fisted
or CSA approved
7/2" strain
relief
G. Green
ground
screw
2. Use UL listed wire connectors
and connect white wires (A)
together.
3. Use UL listed wire connectors
and connect black wires (B)
together.
Fire Hazard
Electrically
ground the blower.
Use copper
wire.
Connect ground wire to green ground screw in
terminal
box.
Failure to do so can resumt in death, fire, or
electrbai
shock.
4. Connect green (or bare) ground wire from power supply to
green ground screw in terminal box and securely tighten.
5. Install terminal box cover.
6. Reconnect power.