Whirlpool UXT4230AD Руководство по установке - Страница 14
Просмотреть онлайн или скачать pdf Руководство по установке для Вентиляционная вытяжка Whirlpool UXT4230AD. Whirlpool UXT4230AD 34 страницы. 30" (76.2 cm) and 36" (91.4 cm) range hood
Также для Whirlpool UXT4230AD: Инструкции по установке и руководство по эксплуатации и уходу (28 страниц), Инструкции по установке и руководство по эксплуатации и уходу (28 страниц), Инструкции по установке и руководство по эксплуатации и уходу (28 страниц)
Печатать страницу
For non-vented (recirculating) installations:
The charcoal filter is not washable. It should last up to 6 months
with normal use.
1. Replace metal grease filter with a charcoal filter. For
information on ordering, see the "Accessories" section.
To replace filter:
1. Remove screw from the grease filter retainer.
2. Turn the grease filter retainer to release filter.
3. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
4. Replace screw in the grease filter retainer.
14
WIRING DIAGRAM
Motor Switch
Off - On
NOTE: Speed 1
not used
C25
Motor Characteristics
Power Supply
120 VAC
Frequency
60 Hz
Amperage
1.2 ±10% A
Wattage Rating
73 ±10% Watts
Motor Resistance
White - Red
17.1 ±10% Ohms
White - Black
13.6 ±10% Ohms
Replacing the Incandescent Light Bulb
Turn off the range hood and allow the light bulb to cool.
1. Disconnect power.
2. Squeeze the plastic lens cover and remove it from the hood.
3. Screw light bulb into socket.
4. Replace lens cover by squeezing cover and inserting tabs
into slots.
5. Reconnect power.
If new light does not operate, make sure the lamp is inserted
correctly before calling service.
Lamp Switch
Off - Low - High
1
2
Lamp Switch
1 - 2
1 - 3 Low
L
3
1 - L High
Rectifier
Diode
Ground
Screw
SE114A
N
L
GND
B
A
A. Light bulb socket
B. Lens cover
Operation
Off