Whirlpool WVW53UC0HV Инструкции по установке и руководство по эксплуатации и уходу - Страница 8

Просмотреть онлайн или скачать pdf Инструкции по установке и руководство по эксплуатации и уходу для Вентиляционная вытяжка Whirlpool WVW53UC0HV. Whirlpool WVW53UC0HV 28 страниц. 30" and 36" (76.2 and 91.4 cm) wall‑mount canopy range hood

Печатать страницу

Install Range Hood

NOTE: Remove protective film from range hood and metal filters.

1. Using two or more people, hang range hood on two

mounting screws through the mounting slots on back

of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install (2) 5 x 45 mm lower mounting screws and tighten.

Use the optional wall anchors if needed.

Connect Vent System

1. Install transition on top of hood (if removed for shipping)

with (2) 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket with

2. Measure from the bottom of the air deflector to the bottom

3. Cut the duct to the measured size "X".

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over

7. Reassemble the air deflector to the duct cover bracket

8. Seal connections with vent clamps.

two assembly screws provided with the Recirculation Kit.

A. Vent cover bracket

B. Assembly screws

C. Deflector

of the hood outlet.

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet

the exhaust outlet from the hood.

with the two assembly screws.