Clare Controls CH-THSTAT-W Руководство по эксплуатации - Страница 12

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Термостат Clare Controls CH-THSTAT-W. Clare Controls CH-THSTAT-W 15 страниц. Wi-fi thermostat
Также для Clare Controls CH-THSTAT-W: Руководство по установке (10 страниц)

Печатать страницу
Upon successful completion, the WiFi Network Status screen will be displayed
•
SSID
Select SSID and press the "Select" button to scan for available networks.
After the thermostat completes a network scan, the available networks will be displayed.
Use the up/down arrow buttons to scroll through the available networks
WiFi Networks
II
Network1
IIII
Network2
II
Network3
III
Network4
New
Done
Scan
Press Join to join the selected network
Press Scan to scan again
Press New to enter a new SSID network name to join

DHCP Configuration

If the network router supplies IP address Dynamically (DHCP):
Select "SSID" from list shown on screen, press "Join" button
•
Or, press the Scan button to rescan for SSID
•
Or, manually enter the SSID network name (Case / character capable)
•
Select DHCP enabled (this is the default mode)
•
Once the router / SSID is selected, the WiFi radio will auto-detect the appropriate
•
security protocol
Or, manually select the security type (Adhoc, WPA1, WPA2, WPA1+WPA2,
•
WEP)
Enter the security key (Case sensitive and character capable)
•
Select Done to save settings
•
Security
Select the security type for the network selected: Adhoc, Open, WEP, WPA1,WPA2
Key
Enter the Passphrase for the network selected.
IP Address (for static IP configurations)
To set a Static IP address:
Disable DHCP by pressing the "-" key
•
Enter IP Address (if static IP)
•
Enter the Subnet Mask
•
Enter the Default Gateway address
•
Enter the DNS address
•
Enter the Port number. The WiFi radio communicates on Port 2000, this
•
should be left in the default setting
Enter the Channel number. Auto mode is the default (recommended)
•
Select Done to save settings
•
Ad Hoc Mode
The Wi-Fi radio can also be placed into Ad Hoc mode which enables Peer-to-Peer
communication without a network router.
Select Ad Hoc in the Setup menu. The default mode is Disabled
•
Press the "+" key to change to Enabled
•
o
o
Select Done to save settings
•
Doc ID 2014-05-223 • Rev 02
Shows network SSID, signal strength and open / locked network status
Join
sets the thermostat IP address to: 169.254.1.1
sets the Subnet to: 255.255.0.0
WiFi Setup
Key
xxxxxxxx
IP
0.0.0.0
SUB
0.0.0.0
GW
0.0.0.0
Done
Select
Page 12