Firesense 60404 Руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Нагреватель Firesense 60404. Firesense 60404 4 страницы. Electric parasol heater

Печатать страницу

ASSEMBLY

MAKE SURE THE HEATER PANELS ARE

FIG. 1

FOLDED DOWN BEFORE MOUNTING THE HEATER ON THE UMBRELLA.

1. Remove the heater brace from the heater body by sliding it downward. (Fig. 1)

2. Place the heater onto an umbrella pole between

1 inch (25mm) – 2 inches (48mm) in diameter by inserting the pole into the slot.

Fig. 2

(Fig. 2)

3. Place the heater brace back on by sliding it upward.(Fig. 3)

4. Secure the heater to the umbrella pole by turning the tightening screw

clockwise until the heater is secure on the umbrella pole.

Fig. 3

5. Using the wire loop at the end of the heater panel, pull the heater panel up

until a click is heard. This means that the panel is now locked into position.

NOTE：DO NOT FOLD THE PANELS

DOWN WITHOUT FIRST PUSHING THE

LOCKING PIN IN.

6．To fold any of the panels down, press

the metal locking pin at the hinge of

the heater panel, then holding onto the

wire loop at the front end of the heater,

fold the heater panel down.

NOTE: WAIT UNTIL THE HEATER PANELS HAVE ALL COOLED DOWN BEFORE FOLDING THE HEATER

PANELS DOWN.

7. When any of the heater panels are folded down while the

unit is on, that panel will shut-off, because on the back of the panel is a shut –off switch so that only two or even

one heater panel can be used instead of all three panels.

Locking Pin

Connect the plug to a 120V/60Hz outlet.

Press the Toggle switch on the unit with the"

"toggle switch only and two heater panels will

panel will activate. Press the"

● ●

activate producing 1000W of heat. Press the two toggle switches together to produce 1500W of heat.

To turn off the heater, press both toggle switches downward.

REMEMBER, portable electric heaters are designed for spot heating or as a supplementary heat source.

They are not intended to be the main source of heat during the cold months.

Overheat protection shut –off

If an overheat temperature is reached, the heater will automatically shut off.

It can only resume operation when the user resets the unit. Inspect and remove any objects on or adjacent to

the heater that may cause high temperature.

To reset the heater:

Turn the heater off.

Unplug the heater.

After 5-10 minutes, plug the unit in again and operate normally.

Caution: You must always take care that there is sufficient distance for safety (at least 3 ft/50cm)

between the apparatus and the wall or other objects or combustible materials.

Avoid the use of an extension cord. However, if you must use an extension cord,

the cord should be NO.14 AWG minimum size and rated not less than 1875 W

FOR YOUR

IMPORTANT INSTRUCTIONS

ONLY USE THE UNIT ON A SECURED VERTICAL POLE THAT IS FIRMLY IN PLACE.

READ ALL INSTRUCTIONS BEFORE OPERATING THIS HEATER.

This heater is not intended for use in bathrooms, laundry areas or similar indoor locations where there may

be moisture. Never place heater where it may fall into a bathtub, swimming pool, or other water receptacle.

OPERATION INSTRUCTIONS

"for 500W of heat. Only one heater

●

SAFETY