Fireside Furnishings Kenwood Руководство по установке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке для Аксессуары для каминов Fireside Furnishings Kenwood. Fireside Furnishings Kenwood 6 страниц. Wall cabinet

Печатать страницу

Apply four areas of high temp. adhesive (each about the size

of large grape) to each marble cleat and insert marble/granite

header in the 1" gap between breast board and backer board.

Holding marble/granite header insert the marble/granite legs in

the gap between right/left cabinet legs and marble cleat.

Carefully lower the header onto the legs. Work header and legs

into adhesive. Make sure that legs are plumb and that there is

adequate clearance to the opening of fireplace.

11.

If the non-combustible hearth is used, cut the vertical pieces of

scribe to allow for stone height between the legs. Place the scribe

molding as shown above, positioning it so that it just contacts the

non-combustible surround. Be careful not to hit the facing mate-

rial when nailing the scribe in place.

www.fireplaces.com

10.

Attach the scribe (g), making sure it is pushed back against non-

combustible facing. It is recomended to predrill 1/16" holes on

the inside scribe pieces prior to attaching them to the mantel to

avoid splitting. Nail with 4D finishing nails (provided), breast board

first. Be careful not to hit the stone as you nail the scribe in place.

Protect the stone with a piece of corrugated cardboard held or

taped between stone and hammer as you nail. Use a nail set to set

the nail head below surface of scribe, and fill the resulting hole

with an appropriate filler.

12.

Cut scribe to

fit stone.

Caulk the cabinet to the wall all the way around, using a caulk that

matches your cabinet color. This will eliminate any remaining gap

between cabinet and wall.

YOUR INSTALLATION IS COMPLETE.

KENWOOD-WALL-CAB

REV. 1

06.17.2009