Bad Boy 7800670 Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Газонокосилка Bad Boy 7800670. Bad Boy 7800670 20 страниц. 21-inch variable speed swivel wheel walk behind mower

Печатать страницу

1. Cutting Height Adjustment

Operation (Continued)

WARNING

DO NOT attempt any maintenance, adjustments or service

with engine and blade running. STOP engine and blade.

Disconnect spark plug wire and secure away from spark

plug. Engine and components are HOT. Avoid serious

burns, allow sufficient time for all components to cool.

Installing the Discharge Deflector

1. Remove the recycling cover. Refer to the Section entitled

"Recycling Operation".

2. Install the deflector (A, Figure 10) to the deck in place

of the recycling cover, making sure that:

•

The front hole (B) on the outside front of the

deflector fits over the stud where the front of the

recycling cover was originally secured

•

The slot (C) on top of the deflector slips under the

restraining nut on top of the deck (under the right

front corner of the engine)

•

The slot (D) on the inside rear of the deflector slips

onto the stud behind the rear of the discharge

opening, where the rear of the recycling cover was

originally secured.

3. Install the internal/external tooth lock washers and knob

nuts onto the studs and tighten securely.

Figure 12: Installing the discharge deflector

Installing the Grass Bag Adapter

(Optional Accessory on Some Models)

1. Remove the recycling cover. Refer to the Section entitled

"Recycling Operation".

2. Install the adapter (A, Figure 11) to the deck in place of

the recycling cover, making sure that:

•

The front hole (B) on the outside front of the

adapter fits over the stud where the front of the

recycling cover was originally secured

•

The slot (C) on top of the adapter slips under the

restraining nut on top of the deck (under the right

front corner of the engine)

•

The slot (D) on the rear of the adapter slips onto

the stud behind the rear of the discharge opening,

where the rear of the recycling cover was

originally secured.

3. Install the internal/external tooth lock washers and knob

nuts onto the studs and tighten securely.

4. Route the recoil rope around the outside of the rope

guide pulley (E).

Note: The recoil rope may need to be slackened. Refer to the

section entitled "Handle Assembly".

Figure 11: Installing the grass bag adapter

Installing the Grass Bag

1. Install the grass bag adapter. Refer to the Section

entitled "Installing the Grass Bag Adapter".

2. Install the grass bag by sliding the connector (A, Figure

12) over the adapter flange.

3. Attach the grass bag hooks (B) over the middle handle

cross bar.

Figure 12: Installing the grass bag

Grass Catcher bags are made of woven fabric, and are

subject to deterioration and wear during normal usage.

Check condition of bag before each use. Immediately

replace worn or damaged catcher bags with only bags

recommended by the manufacturer. The grass catcher

is optional equipment on some models.

WARNING