Ergo In Demand KTG-225 Руководство по установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке для Стойки и подставки Ergo In Demand KTG-225. Ergo In Demand KTG-225 8 страниц. Horizontal and vertical table stands and accessories
Печатать страницуInstallation Instructions
Figure 3: Mount Centris Head with Pole Clamp
NOTE: Equally tighten screws (230) against front pole
mount (210) and the rear pole clamp (220). (see
Figure 4)
(220)
Keep equal
distance between
mount and
clamp when
tightening
Figure 4: Tightening clamp to mount
10. Secure rear pole clamp (220) to front pole mount
(210) and pole by tightening three BHCS (230) using
5/32" hex key (120). (see Figure 3)
KTG-220, 320, And 440 Assembly
To assemble the KTG-220, 320, and 440:
NOTE: If mount is being installed without the base
through a flat surface, proceed to Grommet
Mount Installation.
1. Assemble pole (50) to base (40) using one 3/8-16 x 1"
FHCS (90). (see Figure 2)
2. Assemble pole clamp back (240) to pole mount front
using two FW (250) and two BHCS (260) using a
5/32" hex key. (see Figure 5)
(210)
(60)
(220)
(230)
(230)
(210)
3. Secure pole mount back (240) to pole mount front and
pole by tightening two BHCS (260) using a 5/32" hex
key.
Pole
Pole Mount front
with Array
Pole Clamp Back (240)
Figure 5: Assemble Array Rail to Pole
Display Installation
Attach Centris Head to Flush Mount Display
CAUTION!
CAUTION: If display uses a screw size other than
those included in the kit, DO NOT use the screws
provided. Using the wrong screws could result in
damage to your monitor.
1. Install two M4 x 12mm Phillips pan head screws (160)
into two upper mounting holes in display back.
(see Figure 6)
NOTE: DO NOT fully tighten at this time.
2. Hang display on Centris head. (see Figure 7)
3. Install bottom two M4 x 12mm Phillips pan head
screws (160) through Centris head mounting holes
and into lower mounting holes in display back.
4. Tighten ALL four M4 x 12mm Phillips pan head
screws (160). (see Figure 8)
Model: KTG-Series
(250)
(260)
5