Direct IP Idis DC-S6286HRXL-A Руководство по установке - Страница 10
Просмотреть онлайн или скачать pdf Руководство по установке для Камера безопасности Direct IP Idis DC-S6286HRXL-A. Direct IP Idis DC-S6286HRXL-A 20 страниц.
Также для Direct IP Idis DC-S6286HRXL-A: Краткое руководство (17 страниц)
Печатать страницу
Part 1 – Introduction
Pendant (Inner View)
1
2
Power
1
Network Port
2
Alarm In/Out
3
Video Out, Audio In/Out
4
• Network Port
Connect a network cable with an RJ-45 connector to
this port. You can configure, manage, and upgrade
this camera and monitor its images from a remote
computer over the network. For more information
on network connection setup, refer to the INIT
operation manual.
The table below shows the network cable
specifications.
<The network cable specifications>
Item
Content
Connector RJ-45
Ethernet
10/100Base
UTP Category
Cable
5e or higher
Maximum
100m
length
PoE
High-PoE
10
• Alarm In/Out
3
4
• Audio In/Out DC-S6286HRXL model only , Video Out
Note
10/100Mbps
– ALI:Connect an alarm-in device to this port.
(Mechanism: Choose between an NC (Normally
Closed) type or an NO (Normally Open) type) →
Connect a mechanical or electrical switch to the
alarm in port and the GND (ground) connector.
Alarm in range is 0V to 5V. In order to detect alarm
input from an electrical switch, the signal must be
higher than 4.3V from an NC switch or less than
0.3V from an NO switch and must last for longer
than 0.5 seconds.
– ALO: It is the BJT (Bipolar Junction Transistor) -
open collector output. If the voltage and current
exceed the specification limit (Max load: 50mA,
Max Voltage: 30VDC), the product could be
damaged. When connecting the device which
exceeds the specification limit, refer to the picture
(circuit) below.
If used with an external inductive load(e.g. relay),
a diode must be connected in parallerl with
the load for protection. Otherwise, the product
could be damaged.
– A_I: Connect an audio source to this port. (line in)
– A_O: Connect an amplifier to this port (line out).
This device does not feature a built-in audio
amplifier unit and therefore requires the user to
purchase a separate speaker system with a built-in
amplifier.
– V_O, GND: Connect the cable's signal line and
ground line to these ports and the connector on
its opposite end to a monitor. Use these ports
for previewing video and not monitoring video.
Go to Remote Setup (Video – Camera menu >
Miscellaneous tab) and choose a video out signal.
(NTSC or PAL)