Since Integrity Control is a purchasable option, before the Security Level can be set to Integrity Control this
option must first be installed on the device; enter the installation key for the Integrity Control option provided by
Xerox when the option is purchased in the appropriate step in the instructions under "McAfee Embedded
Control" in Section 4 of the SAG.
To install Integrity Control from the Control Panel perform the following:
Press the Machine Status button and then the Tools tab.
Touch Device Settings > General.
Touch Feature Installation.
Enter the installation key for the Integrity Control option provided by Xerox when the option is purchased in
the 'Enter Feature Installation Key' text box.
Touch OK.
21. Erase Customer Data: Initiate the feature to erase all customer date from the device at the Control Panel by
performing the following:
Press the Machine Status button and then the Tools tab.
Touch Device Settings > General.
Touch Erase Customer Data.
Touch the Erase Customer Data button. A second screen will be displayed; touch the Erase Customer
Data button a second time to initiate the erasure of customer data.
d. The following protocols, services and functions are considered part of the evaluated configuration and should be
enabled when needed:
TCP/IP
Date and Time
Copy
Embedded Fax
Fax Forwarding on Receive (for received Embedded Faxes)
Scan to E-mail, including email encryption and signing
Workflow Scanning
Scan to Mailbox
Scan to USB
Print from USB
Print from Mailbox
NTP
SMB Filing
When setting up the device to be in the evaluated configuration, perform the following special setup for the above
services (otherwise follow the appropriate instructions in the appropriate section of the SAG to set up and/or
configure the protocol/service/function):
1. TCP/IP:
Enable IPv4 and IPv6 from the Control Panel by following either the instructions in "Quick Setup Home" for
using the IP Address Settings wizard under Initial Setup at the Control Panel in Section 2 of the SAG or the
instructions for "Enabling TCP/IP" under "IP" in Section 3 of the SAG. Configure IPv4 or IPv6 by following
the instructions for "Configuring TCP/IP Settings at the Control Panel" under "IP" in Section 3 of the SAG
Set up and configure IPv4 and IPv6 from the WebUI by following the instructions for "Configuring IPv4" and
"Configuring Settings for IPv6", respectively, under "Configuring IP Settings in CentreWare Internet
Services" under "IP" in Section 3 of the SAG.
2. Date and Time:
Ensure that the date and time on the device is correct and is set for the correct time zone where the device
is located. Set the date and time from the Control Panel by following the instructions in "Setting the Date
and Time at the Control Panel".
Set the date and time from the Web UI by following the instructions in "Setting the Date and Time in
CenterWare Internet Services", both under "Setting the Date and Time" in Section 10 of the SAG. Ensure
to set the 'Date and Time Setup' option to be Manual (NTP Disabled).
3. Embedded Fax:
7
Печатать страницу