• Single-Step Transfer (SST)—Special paper used to transfer full-color images directly from
copies or prints onto fabric or other types of materials.
• Labels—Adhesive-backed, pressure-sensitive label stock.
Color Mode
CMYK/Grayscale
The default setting for printing reflects the Color Mode specified in Control Panel
N
:
OTE
Setup.
• CMYK—Enables both Contone and Halftone Printer Mode options.
• Grayscale—Enables Contone Printer Mode option only.
The ACA 1 and ACA 2 settings are no longer available.
N
:
OTE
Sharpness
Softer/Normal/Sharper [Normal]
• Softer—Decreases the clarity of the printed image.
• Normal—No adjustment is made to the clarity of the printed image.
• Sharper—Increases the clarity of the printed image.
This option is available on MajestiK and Regal color copiers only .
N
:
OTE
Calibration/Simulation
Copier/SWOP-Coated/DIC/Euroscale/Linear/Custom-1/Custom-2/None [Copier]
Calibration/Simulation allows you to change the calibration curve currently set on the
Fiery XJ for the current print job only . As the job begins processing, the target selected in
Calibration/Simulation is loaded and applied before printing. Once the print job is
complete, the Fiery XJ returns to its previous calibration curve.
You are able to select targets that reflect those currently existing on the Fiery XJ. If you
select a target that does not exist, a PostScript error results and the job does not print.
• Copier—Uses the current copier calibration target set in Printer Setup on the Fiery XJ
Control Panel.
• SWOP-Coated—Uses the United States press standard.
• DIC—Uses the Japanese press standard.
• Euroscale—Uses the European press standard.
• Linear—Divides the maximum measured density for each color into equal, linearized
density steps, providing an even distribution of tones over the copier's density range.
• Custom-1—Uses a custom calibration target. Before selecting this setting, you are
required to create a new target in Fiery XJ Print Calibrator and name the target
"Custom-1".
• Custom-2—Uses a second custom calibration target. Before selecting this setting, you are
required to create a new target in Fiery XJ Print Calibrator and name the target
"Custom-2".
• None—Disables calibration.
For more information about calibration, see chapter 6 of the User Guide .
Page 6
Печатать страницу