Xerox DC240 - DocuColor 240 Color Laser Примечание к выпуску - Страница 6

Просмотреть онлайн или скачать pdf Примечание к выпуску для Сканер Xerox DC240 - DocuColor 240 Color Laser. Xerox DC240 - DocuColor 240 Color Laser 34 страницы. Overview of the control panel buttons.
Также для Xerox DC240 - DocuColor 240 Color Laser: Краткое руководство по эксплуатации (2 страниц), Руководство по замене оборудования (2 страниц), Краткое руководство по эксплуатации (2 страниц)

Page 6

See the following Cisco web site for more information about the protocols related to

OTE

this issue:

http://www.cisco.com/en/US/tech/tk389/tk390/

technologies_tech_note09186a008017f86a.shtml

Alternatively, you can try using a different switch or putting a repeater (also called a hub or a

dumb hub) between the Fiery and the switch.

NDS Setup

In Network Setup, if you want to enable both PServer Mode and NDS, ﬁrst select the Enable

PServer Mode check box, and then wait until the cursor returns to an idle state before you

select the Enable NDS check box.

NDS trees not displayed

If you set up NetWare Printing (PServer) and no trees are visible, make sure that the IPX

frame type (under the Protocol2 tab) is set to Auto. If you must set it to Manual, make sure

that only IPX frame types with non-zero network numbers are enabled. For example, the

IPX address 01-00-80-22-00-E0-81-56-19-1B is acceptable, but 00-00-00-00-00-E0-81-56-

19-1B is not. If you switch from Auto to Manual or Manual to Auto, reboot the server before

proceeding.

IPX Frame type

In WebSetup, under Network Setup, you can select multiple IPX Frame types. However,

Network Setup on the copier Control Panel allows you to select only one IPX Frame type,

and if you have selected multiple types through WebSetup, only one is shown in the copier

Control Panel.

Changing network settings

If you change any network settings in Setup from the copier Control Panel, the Fiery reboots.

The Fiery loses connection with the copier until it has ﬁnished restarting, which takes a

minute or two. To determine whether the connection has been restored, press the All Services

button. If the Network Scanning button appears dimmed, the connection has not been

restored.

Maximum number of users for SMB

The Fiery supports a total of eight simultaneous SMB connections, including the

Direct connection, Print queue, and Hold queue.

Windows 2000 and LPR availability

When you perform a clean installation of Windows 2000 on a client computer, no LPR

services are available by default. Your only option is to print through a standard TCP/IP

port, or use SMB printing. However, if you converted a Windows NT 4.0 computer to

Windows 2000, LPR printing services are retained.

Part Number: 45045321