Xerox WorkCentre 6400 Руководство по конфигурации - Страница 11

RF IDeas: pcSwipeConfig.exe

ID TECH; USB Swipe & Insert Reader programming tool

http://www.idtechproducts.com/index.php?option=com_docman&task=cat_view&gid=298&Itemid=79

MagTek: MiniMag II Configuration Software

http://www.magtek.com/support/software/demo_programs/usb_swipe_insert.asp

ID TECH Magnetic Stripe Reader Configuration Upgrade

Software can be found at:

configuration-software.html

Select the IDTech_Xerox_Config.zip file to access the ID TECH MagStripe Configuration file that will be

required later in the setup process. The file is located within the

mentioned in the Prerequisites section.

Save the file to your PC for later use.

After installing (note: requires a restart) and running the Magstripe Configuration Utility:

1. Select Reader Interface button.

2. Select "USB"(Radio button below USB picture) and then select "Continue":

The reader will beep a few times and the screen will return back to the default view.

3. Select "Change Basic Reader Settings":

4. Select "Load from File":

5. Navigate to where you saved the configuration file, then select it followed by "Open":

You should get a message that loading the file was successful. Select "Ok":

6. Select "Send to MSR":

Reader will beep once or twice and you see a message that the settings were successfully

written.

7. You are now done programming the reader. Select "Close" and then 'EXIT':

http://www.rfideas.com/Software/

http://www.idtechproducts.com/download/swipe-readers/doc_download/38-

USB_Card_Reader_Install.zip

USB Card Reader Configuration Guide

file