Xerox C8 - DocuPrint Color Inkjet Printer Руководство - Страница 2

Просмотреть онлайн или скачать pdf Руководство для Программное обеспечение Xerox C8 - DocuPrint Color Inkjet Printer. Xerox C8 - DocuPrint Color Inkjet Printer 13 страниц. European harmonic current notice
Также для Xerox C8 - DocuPrint Color Inkjet Printer: Процедура очистки (2 страниц), Руководство по началу работы (40 страниц), Инструкция по эксплуатации (1 страниц), Примечание к выпуску (26 страниц), Уведомление (1 страниц)

Ou t p u t Cu r l a n d De c u r l i n g De v i c e s

Paper curl is caused by a variety of factors. Many papers tend to curl toward one side after toner is

applied and fused. For some paper products, paper curl variability may be evident from batch to

batch and even from ream to ream.

The DocuColor 8000AP / 8000 / 7000AP / 7000AP has an automatic curl control system that uses a

number of variables to adjust the amount of pressure applied by different decurlers in an effort to

reduce as much curl as possible from printed output. Default settings are programmed in the system

based on equipment design parameters; however, the default settings may not be appropriate for all

papers.

Most of the papers designed for xerographic use indicate the preferred printing side with an arrow on

the ream label. Follow the manufacturers' suggestions for first image side, and load paper with the

arrow pointing up for onboard trays 1 and 2, as well as Secondary Feeder Module (SFM) trays 3 and

4. If the output prints have too much curl, first try flipping over the stack of paper in the paper tray

being used.

If flipping the stack of paper over does not resolve the curling problem, enter the Tools Mode and

manually select a new decurler setting for the paper. Refer to the DocuColor 8000 / 7000 System

Administration Guide for information on how to access Tools Mode and the Decurler Setup screen.

The four pre-programmed decurler settings are named A, B, C, and D and refer to a set of

parameters that characterize how a particular paper interacts with the DocuColor 8000AP / 8000 /

7000AP / 7000 decurling system. Select a different setting for the tray, type, and weight of paper with

a curling problem, then exit Tools Mode and re-run a few sheets using the new setting. A difference

in behavior should be visible, but if output curl remains unacceptable, try additional settings until

desired output is achieved.

Six additional settings (E1-E6) provide additional adjustment flexibility based upon actual output curl

measurements.

To use settings E1 – E6, you must first program these settings to match paper grade, type, area

coverage, and environmental conditions. Refer to the DocuColor 8000 / 7000 System Administration

Guide for instructions on programming these settings.

Ou t p u t Co n s i d e r a t i o n s a n d B & W Pr i n t i n g

DocuColor 8000AP / 8000 / 7000AP / 7000 performance is tightly linked to good media selection and

adequate job creation. For particular applications, using coated materials will improve image quality.

The DocuColor 8000AP / 8000 / 7000AP / 7000 can be used to produce black and white documents

as well as color. Because of the way black and white documents are processed and fused, you will

need to run a fine grain paper when running jobs with blocks of solid black. For these jobs, try using

For more information on Genuine Xerox Supplies, call 1-800-822-2200 in the USA and 1800-668-0133 in Canada